I suspect that my igniton coil is going bad. The jeep starts fine and runs like a top until the engine warms up and themn i lose all igniton...
My m38a1 is still set up as a 24 volt set up, but according to my voltage tester, if I wire to the second battery in series, I am getting twelve...
The Tank on my jeep has some set of inner walls that do not allow me to just pour out the old gas and what sediment lies with it. Does anyone...
I was searching the old threads on power steering and came across this link. Does anyone have experience with installing one of these? Are there...
I flattened my muffler pipe between a stump and the cross member which lead to horrible backpressure results. :mad: I have cut out the flattened...
The starter peddle on my jeep is sticking, and I'm not real sure why. I have never had this problem before. Has anyone experienced this and if...
I have completed the transmission transplant surgery on the M38 and my neighbor and I took her for a test drive around the neighborhood. It felt...
After a few hours of three guys, an engine lift, a few wrenches, a lot of gear oil, a sledge hammer and a 5 foot cheeter bar, the engine, tranny,...
I got a little carried away today and put the tranny, transfer case, clutch bell housing, and engine all back together. Now I have to figure out...
I have read through the article about rebuilding a Tranny and have one question that I could not find an answer to. Once the Tranny and Transfer...
Does anyone know or can someone tell me where to look for the following torque specs for a 53 M38 A1: Engine Head bolts Clutch plates...
I'm sure there are past discussions on this, but my search was not succesful. The data plate was missing when I bought my 53 M38 A1, and I would...
I'm trying to get my jeep to comfortable ride condition while I am restoring the trany. I'd like to replace the shocks right now, but am not too...
Separate names with a comma.