So you are looking for just the compression to NPT adapter? Like here: http://www.summitracing.com/parts/NOS-16432NOS/ Or here:...
And your pictures woked very well for me to build my mount. Thanks again Dave. :D
Your shackle angle looks good. Right around 60ish degrees?
One other thing, on your steering box, draw a line across the input shaft face. Count the teeth on one half multiply by two and you have your...
Fish plates are diamond shaped pieces of steel that would go over the seam of your patch with the fat part right at the seam. It would cross over...
It's not that bad. It is basically a 1/2" round solid brass rod that you use instead of a steel punch. Brass won't hurt the steel as it is much...
I just read your thread so I maybe posting some info you already have dealt with. Square your hole first then weld your patch in. Flat bar or...
Get a brass drift and pound it home.
Looks good :beer: What rear corners are those?
You can adjust the frame side pivot ball by lossening the bolts that hold the bracket it mounts to on the frame and pushing the mount towards the...
You might also try giving the output shaft a spin while pushing down, but not too hard, on the cable.
Yes :beer:
I agree, washers would be just fine. As far as the torque goes I use locknuts and tighten them down just enough that the washers on the outside...
Correct, the two that get power, one for the high beams the other to the indicator on the dash.
Linky no worky
Hmmm. I stand corrected. Got to love a Haynes manual.
The "little box" in the last pic is your voltage regulator. In the first pic, what wire are you talking about. The one on the negative side...
You should have the ballast resistor in there right before the coil. But if you are running an aftermarket ignition like an MSD box, you would...
I snagged one out of an '80s Cherokee. It is a GM coulumn they are all roughly the same from that era, they length of the column is a little...
x eleventybillion. Wire wheel that sucker and line it. Maybe add some structural beef around your cage mount, put it back together and enjoy.
Separate names with a comma.