I'm knee-deep into replacing seals and gaskets that don't require removal of transmission or transfer case - so far, so good! I've pulled both...
Just finished replacing rear main seal (engine in jeep) and was able to change upper seal without loosening other main caps or turning the crank....
I've been having alternator charging issues since I switched over from generator a couple of years ago. I installed a 105amp 12SI Delco...
I'm installing a 21 circuit EZ Wire kit in my '61 and am to the point of connecting wires to the lights/gauges on the speedometer. I didn't pay...
Just finished today. Been working on it off and on for several weeks. Also opened Photobucket account for pics. Lets see if this works. [IMG]...
F-134. New problem. I replaced the water pump due to a leak, thermostat housing, thermostat (180), upper and lower radiator hoses, fuel pump, oil...
:eek: Well - not technically, but that's what the ramps measure! R) Just finished 'em. No more just barely getting under the Jeep on the...
Finally got the seat cushions upholstered and installed. :)
I'm installing an EZ - 21 circuit wire harness. Since the fuse block has a 30A fused circuit for the headlights and I'm using relays for the high...
I've been carrying around a big plastic tool box (unsecured :roll:) in the bed of the jeep for some time now to carry oil, antifreeze, recovery...
Needed a way to hold beverages (or other stuff). Used 3" PVC and 1/8" plate. Screwed through bottom of plate into edge of pipe and used #6...
Been doing a little fab work and needed a grinder holder/table to be able to produce better quality parts. Had everything on hand except metric...
Here's the plan - order 105amp 12SI Delco alternator, bracket and pulley from Quick Start Automotive Electric, EZ 21 harness from EZ Wiring, and...
In a couple of weeks, my seats are going to the upholstery shop to be rebuilt/recovered. I've seen an example of the stock seat pattern on the...
Everything I read about using shoulder/lap belts with stock low back seats cautions against this. I know Boyink did this installation - anyone...
D-ring and towbar brackets made from 3 x 3 x 3/8 angle and 1/2 plate. Had to try em out before painting.R)
I'm thinking about using a PVC single ply membrane for a bikini top, but I've never seen how a bikini top attaches to the windshield channel. Has...
Here's a bracket I made to install one of the cheap electric wiper motors above the windshield using the stock mounting holes. The material is 1/8...
"I didn't make this table - it was a leftover from a construction project and the welder left it behind. I'll get a better pic of it this...
Console and battery hold down bracket.
Separate names with a comma.