I need the piece of metal that was used for the transfer case torque. I have the rubber part but I need the thick piecof metal. It attaches to the...
I learned a new word today. It took me since the August Colorado Epic trip to re-wind my winch cable on straight. Finished it today. Next drain...
Rich M. and James O. reccomended I make a few changes to improve my wheelin with them. I had some problems in Colorado Epic. James and Rich...
I am switching to a cable accuated clutch. Normally you would order a 58 1/4" cable from Inline Tube, however my transmission is an SM465. Much...
Looking for a clutch bracket that attaches to the transfer case of a dana 18. I am switching to a cable actuated clutch. I will add pictures of...
Looking for where to find a magnetic clock to stick on the dash. Battery operated. Any ideas who might have them?
https://www.facebook.com/commerce/listing/587313180186006/?media_id=0&ref=share_attachment
I have a 1971 cj5 with the BDS 2.5 suspension and stock original shackles. I have 31"X10.50"x15". I am going to put on some 33x10.50x15 tires with...
In my 1971 cj5 I did some upgrades just like James's write-up. When done with the knuckle stud upgrade I checked to make sure I had full swing...
What happened Tarry99? I tried to reach out to him, however no answer. Thanks, Julius
I would like to hear from anyone that has switched over to the wilwood M/C and the remote reservoirs. I have disc/disc setup and was looking for a...
I bet that jeep would bring quite the price tag. What are your thoughts?...
Thanks to all the good people who got me through my upgrade. James for the steering knuckle upgrage. Rich M. for educating me on DOM tie rods....
Well I was just completeing my dana 27 2 hole steering knuckle tie rod flip. Everything had good clearance and I found no problems. So I finally...
I plan on putting some 33" x 10.50 x 15 tires and wheels for off road trips. Do I need to add different front shackles to prevent rubbing. Right...
I am having a little trouble coming up with the correct tie rod ends for my steering linkage upgrade. It's a 1971 cj5. I have recently added a 2...
Well I was doing the knuckle stud upgrade like James fino did. After I set the kingpin bearing preload to 16 lbs pull I put the metal rubber seal...
I seem to be having a problem in purchasing the needed bushings to do the tie rod flip. The website won't let me purchase the needed bushings and...
Does someone out there have the spot face counterbore bit? I am doing the buttonhead bolt mod and need to spot face where the bolts go in through....
My first jeep I built was a 1945 mb. SM420 4spd Dana 20 tc limited slip dana 44 rear Warn 8274 winch 4.88 gears final crawl 77:1 IMG_1780 by...
Separate names with a comma.