Tried to post a pic of the generator but apparently I do not have that option (permission)
I'll confirm tomorrow and reply.
Not yet. Busy with Christmas and wasn't sure how to flash the armature
I have a completely original 66 cj5 with generator. I left a sprayer switched on for 2 weeks and killed the battery. I recharged the battery and...
Ive got a pair of Tan Bestop high backs in my 66 CJ5 and they work fine, ride well & bolted directy to the original rails. No complaints. You can...
I'll check later but pretty sure the 104 is the canister filter for the F134. The gasket goes in the top of the canister.
Thanks for your feed back. No, its not butchered up. I figured out the problem last night and I'm embarrassed to admit how simple it was....
I need some advice on the proper vacuum line configuration for my 66 CJ5. I've read all the related links, below is the one everyone seems to...
Yeah its an under the seat original tank. The rubber seal is new and working fine, From what I've read, the cap is the vent source so its not...
I had a similar problem with my 66 CJ5 and constantly found it necessary to adjust the fuel mixture. It'd work for a while then start idling up...
Anyone know if you can get a trim kit to mount around the gas tank filler area on 66 CJ5? When the tank is filled, gas weeps out on rough trails...
Looks very nice! Where did you get your seat belts? I had the inside of mine Rhino-Lined and I like it (quieter and cooler). We took all the...
Re: Calibrating temperature gauge readings 66 CJ5 :) OK, I found you can calibrate the guage and sending unit by adding a resistor in line. I...
Go to this and you should find the answers. http://www.film.queensu.ca/CJ3B/Tech/FuelGauge.html In short, I don't think the fuel sending...
Will do, I'm going to see if I can find a 10 ohm resistor and put it in line between the gauge and TSU just to see what it does. Eddy
Thanks, No I did not disconect the TSU. I will do that and retest the resistance between the terminals. Great suggestion. And I did a search...
I'm trying to get everything original working correctly in my 66CJ5 with f134 engine. I just installed a used but original configuration temp...
Thanks for the leads, been on vacation and just getting round to reading the advice. Thanks. Eddy
I just cleaned and relubed my vacuum wiper motors and they work fine. Now I want to run new vacuum lines to them but I am not sure how the lines...
Separate names with a comma.