It started out as just an occasional chirp, every once in a while, once warm, at an idle with the clutch in. Well, every once in a while has...
Mine is leaking from the weep hole so it’s time to replace but I was wondering just how difficult it would be to rebuilt. So, anyone ever done...
Why are they so hard to get? Fastenal sent me to a local machine / performance shop, they're sending me to Cat Tractors out in the industrial...
Time to place your bets on exactly how I screwed up replacing the clutch plates in the rear Dana 44’s Power Lok. Axle: full float converted Dana...
Sorry if I'm bragging but I did, you know. Score, that is. [IMG] [IMG] [IMG] I'll be digging through the archives for some help...
A while back someone posted a chart of the clutch plates for a Power Lok showing how they could be shuffled around to get different traction...
I need to have my crankshaft turned and polished and am looking for a machine shop in the area, within a 100 miles or so, that can do the job....
The nuts / bolts that hold the drive shaft to the companion flange keep shaking loose and it’s getting on my nerves. Anyone ever put studs in...
Re: SM465 Tranny? I did this conversion on my 71'. Second best mod I ever did, right after the detroit. The rear driveline is short but not so...
Anyone know much ‘bout these? Mine was jammed up in 3rd gear. I’ve taken it partially apart, enough to get at the speed clutch, hub and...
Re: Overdrive? Nice buy, you scored. I really don’t mean to hijack your topic but I have a question since the OD gurus are assembled. How are...
How I grenaded the ring and pinion in my front diff, a Dana 25, is a long story but I’ve got new, used, replacements and am have’n troubles...
Was there ever a Dana 27 front or rear that had 8 bolts hold’n the ring gear to the differential carrier instead of 10? If so, what was it,...
I used to have a parts store saved in the “favorites” on my puter but now I can’t find it and I’m ready to rebuild the Powr Lok in my Dana 44...
How close is the wheel hub off a Dana 27 to that off a Dana 30? I’ve recently purchased a set of knuckles off a Dana 27 and they were sent to me...
Separate names with a comma.