What would be the most effective way to prime the oil pump on my '71 225 v6? I've recently had the heads machined and doing some engine...
OK jeep got to where it wouldn't crank up so I replaced to coil, condenser, rotor, and put in a new set of points. the points gap is set to 0.016...
ok, in the last month I've gone through 2 or 3 of those cheapo $12 dash-mount ignition switches from AutoZone. Is there a heavy duty application...
I want to make my own "lift shackles" for my 71. I have all the materials but wanted to know what is the optimum length for shackles. Really I'd...
ok, let me make sure i have this right. My running lights/turn signals all work. for the brake lights to work when the brake is applied...
Could anyone tell me what exactly this is?
I really like the look of the MB /2a/3a speedometers, and it just so happens that it matches my recently purchased gauges. Does this speedometer...
Could a CJ5 frame be stretched to accomodate a cj6 tub?
ok i just got my new headlight switch in from napa, but it looks nothing like my original. it has 6 terminals and looks like this: (was...
Do the brake lights require the turn signal switch to work properly, or is there a way I can get them to work WITHOUT the turn signal switch.
Was looking through my 4wd hardware magazine, and saw this: http://www.4wd.com/newsite/shop/productdetail.asp?pid=20046 My stock heater.....
DO any of you guys use the Teraflex Revolver shackls on your cjs? I've been looking at them in the magazine.. just wondering if they do all they...
would a binding noise in the driveline be caused by the height of the transmission mount (being could i drop / lower the crossmember to get rid of...
OK, I just recently put in a new clutch, and replaced all of the gaskets, seals, ball bearings, roller bearings, snap rings, and basically the...
I just bought a new light switch but its nothing like what came out of my jeep. it has a few more terminals, etc. If any of you guys could help...
Well back to my original problem of the horrible noise from my t-case / trans. turns out i goofed up the mainshaft quite a bit because i dropped...
Could someone please tell me what this is (I think it might be a CAT ignition?) It's hooked up to my winch/battery. If its just being used to...
Any of you guys know off the top of your head (because I can't find it) the number of roller bearings required for the mainshaft in my T14. Thanks.
I came across some free seats, but without any kind of bracket or anything, so I'm going to have to fab up something. Any of you guys have some...
I guess I better ask before I do, but if I pop the welds on the tool box ont he passenger side to remove it, will it just leave the floor pan like...
Separate names with a comma.