I have a 63 3b and the engine # is CJ10451 but from what i have read that doesn't fit the numbers associated with 3b"s and was wondering if...
Re: m101 thanks guys this is good information and i will definately consider it..I also found out the bolt pattern now is 5 on 112mm(4.4) George
I just bought a canadian m101 trailer and would like to know the bolt pattern for the wheels??? also if i was co convert them to the 5 on 5.5...
[IMG] [IMG] This has been for sale for sometime now and since my '63 cj3B is almost finished (spring)I figured it was a good xmas present for...
thanks so much Sammy....I am really grateful as this is the last big ticket item i need...thanks again George
I have a 63-cj3b and was wondering the correct sizze rims for it to be orginal??? i know they are 16" but what is the width?? thanks guys...
thanks ever so much Oz i truly appreciate that but where did you take the measurement from the left from???Outside of tub,end of dash??????...
I bought a new repo tub for my 63 cj3b and i need to cut the holes in the dash and need a starting point??? lets say the center of the speedo...
Will these help [IMG] [IMG] [IMG]
Thanks guys as you can see i don't know much but am willing and anxious to learn!!!i will be lookin for more info as i go along i'm sure:oops:
Thanks for that info Old Bill but the serial # reads 57348 so maybe i don't really have a 1963 after all????????
I am finally startin my project!!!(1963 Willy cj5)The wiring is all chewed up and disconnected and i am wondering if anyone has a Wiring diagram...
thats a great question as i was wondering the same thing about my 63 cj5?? hope someone has the chart for it as it would be nice to find...
I'm not sure on where to put this but i guess someone will tell me!! I need a set of Edelbrock shorty headers for my 304!!! I was wondering if...
so if i should buy lockouts then which ones do you all recommend??? and thanks for all the valued info .....Lynn was right you are a friendly...
thanks blevisay !!!
i just went and took one and thanks [IMG]
i just was out lookin at my 63cj5 and it doesn't have lockin hubs on it?? Is this the way it is supposed to be or did PO do something to it?? Thanks
my 63cj5 has a 134 motor but what would the rest of the drive train be???trans,transfer case,front and rear axles ?? Thanks
The same thing happened to my 78 cj7 and i was wondering what the hay and it turned out to be the batery and it was great 2 days before that !!!...
Separate names with a comma.