Howdy All, I am getting old and have a pile of parts left over from years of projects. I don't need another four wheel drive vehicle so I...
Can you ID this transfer Case? http://postimage.org/gallery/180l5j4fc/
Howdy, want some of your thoughts on whether to complete a full cage or not. The reason for the question is this; I already have a roll bar, and...
Hello, Does anyone know which vehicle had the longer shift levers for the Dana 18 transfer case? Was it in the pickups or wagons, as I have a...
Hello, I am looking for help in installing some seat belts/or harness in my CJ2A. Any advice and pictures on your installations would be great....
I did a search on this but did not find the answer I needed. I am about to order a tilt column for my CJ3A, and would like to know what length to...
Hello, has anyone cut off and run there front fenders without the (Front Fender angle supports)? Mine are in bad shape, but the rest of the...
Hey Sparky, so how does that V6 pull those 33" tires with 3.73 gears. Are you happy or would you like to go lower for all around driving on the...
Hi All, I have read some post about putting in a 1970 CJ5 rear tank in a early CJ. Looking for some advice, are there any issues with the rear...
Hi All, have been in the process of putting a V6 and T18 in my CJ and have a question. Does anyone have pictures on how they covered up the shift...
Hi All, I am mounting my Dana 30 in my CJ2A, with wrangler springs. What is the best position to mount the shocks, in front of the axle or...
I have a Chevy dual master cylinder were the brakes share the same reservoir as the clutch in my CJ2A. I want to put Disc brakes on my CJ2A and...
Another Idea, would my Chevy inline 4 (153 cubic inches) be able to pull a turbo 350 automatic transmission with out to much power lost? So what...
Doe's anyone know if a T15 transmission can be swapped in place of a T14 transmission? I am using a T14 and a Dana 20 from a 69 Jeep with the...
I just got through looking at parts, and I don't see much difference in the rotors from a Ford F150 and the Jeep rotors for this swap. The...
Hi All, I need to replace my axle bearing on a flanged axle dana 44 (1971 CJ5), did they change from a pre-greased bearing to a bearing that...
Hello Guys, I have under-construction a Cj3B with a 225 V6 and need advice on a gear ratio. I have been to the websites on how to calculate RPM...
I have a 153 cubic inch, inline chevy four, with a T14 and dana 20 TC in my 48Cj2a. I have a chance to install a ford T18 four speed, which I...
Separate names with a comma.