installing a lockrite locker in the front axle. Pulled the front cover and drained the oil. also puled the hub and brake drum. Not shure where to...
The last time I rebuilt the carb I had trouble finding a rebuild kit. I could use some help with a supplier and part number. Quality counts THANKS
My wipers would cam over and lock up, then I would have to remove the arms and turn the wiper motor back on for the linkage to reposition....
Just rebuilt T-14 trans. I had to replace the needle bearings to the main shat coming out of the front of trans. It seemed to be a lack of oil...
Instead of changing my stock t14 trans to a sm420 for the low first gear, I am considering a tera low kit for the d18 t-case. Any opinions on...
I am trying to find a source for a oil pick up tube for a 68 225 odd fire. Called quite a few places with no luck. Evenen a good used one might...
I have a rear fuel tank that needs to be replaced. The gas cap is located on the rear drivers side behind the tire. The tank I have now fits...
I need to know how to tell the difference between the two when looking for a new axle for my jeep. Heading out tomorrow to look at one for sale...
My 68 cj5 was finally drivable after 2 years of work. I was at least able to take it for a few short test drives around town. Next I took it out...
I had a cracked timing chain cover and replaced it with a new cover that had ben machined incorectly. I could not get the distributor to go in...
While cranking the engin over my voltage drops from 13 plus volts to low 10 to high 9 volts. I am thinking this may be my problem. I have a new...
I have power to the distributor, but no spark at the pins on to of the distributor cap. I need to now how to test the other componets coil ect. I...
I spent about 3 hours yesterday trying to get my new hei distrbutor to drop in and line up with the oil pump. Any tips or tricks ? 225 v6 odd fire
I am installing a painless wireing harness and I am confused about witch wire goes to what spade on the back of the ignition swith. Right now Im...
Where would you atatch the oil presure line to a 225 odd fire? Im installing an oil presure gauge.
My original 68 cj5 front front seats need new foam and vinal. Any sugestions? Can I get new original style seats with a fold and tumble passenger...
I just purchased a mean-green starter for a 225 odd fire and it wont bolt up correctly. I think they have sent me the wrong adapter block. Do you...
Im wondering if I have my rear axle shims in right. Thanks to your help I realized I had the front ones in backwards. I have the rear shims in...
Has anyone had a problem with thier right hand tierodend hittting the spring. Need a solution, am considering a spacer plate betwene the spring...
Separate names with a comma.