Tank is a 35 gallon Horizontal Leg Tank, 29 inch long, 20 inch diameter, 5 inch fill opening. Weighs 350 pounds when full of water Trailer is...
Hey guys I hate to beat the dead horse. I searched and did not find the answer I was looking for. I have the stock drivers side heater and want...
Anyone know what happened to HW Industries? They made the Jamboree and their link is dead. They go out of business? :?
Is this tranny mount a custom fab or off the shelf? It's from a sweet 73 I found on the list and I kinda like the setup for mine if it will work. :?
A while back I did a search for mounting my tranny and tcase to the cross member and read that I need a F Head MM. Well I ordered it and there is...
Re: Rebuilt Rochester 2G overflowing Don't mean to high jack this thread but concerning the float. I'm rebuilding my carb as well and it...
Errr, half the bantam I use to be? :? :roll:
D44 and a D27. Owner say's he installed aftermarket 5.38's gears in both about 500 miles ago. They are out of a 66. He wants $100 for the pair....
That a Dana 30 off a 66 Bronco will bolt up directly. The donor is stock so I'm hoping for 3.73. I'm getting it for free... ;)
Is there a way to measure how much lift I have on my CJ? I don't know what the PO did to the suspension and was looking at some kits. I was...
There's an inch vertical gap where the hood meets the firewall. The gap spans in the middle between the hinges. From the hinges down on both...
Hey guys- I scored a set of backing plates complete w/ all the guts in my local area. Cylinders appear to have no leaks and the shoes, springs and...
Are the splines engaged? Aligned with clutch tool and I've jimmy'd it every which way. I still can't muscle the tranny any closer. I'm bout ready...
Do they go under or over the ball stud?:? Don't want another TB incident. :roll:
NOTHING GOES RIGHT? I can't believe that I installed the throwout bearing inside the clutch house and tightened the bolts! I feel like such an...
After much debate on what you guys said about fixing that stripped out FP bolt correctly, I went and did it. Thanks Mcruff, you was right on fix...
Guys how do I install these stupid number tags onto my plug wires? Is the orange stick some kinda tool to install? I tried pressing one tag on a...
Is this gasket the rubber O ring that's around the distributer shaft or a flat gasket that goes between the the distributer flush with the block?...
My regular dist has numbers on top of the cap. Where is Number 1 plug on my HEI cap? Does it matter which way the cap goes on? Universal plug...
Please tell me what book this pic came out of. Unless I'm blind, I cant find it in the FSM or Chiltons. :? Thanks
Separate names with a comma.