Wow, lots of great information. I just recently redid my dash and decided to take the speedo apart just to clean it. What a huge difference, looks...
You can buy TREs for a M38A1 too. They are the same taper as regular CJ ones but have a bigger .75 inch threaded shank. I used these, jam nuts and...
I just went with these.http://www.jcwhitney.com/wcsstore/jcwhitney/images/imagecache/G_21370G_CL_1.jpg $139 with free shipping from good ole...
Cool. Thanks for the feedback. I'll probably just get the replacement lowbacks.
Kind of an old thread, but I was looking at these from JCWhitney. Anybody have any experience with them?...
The high steer arm on the passenger side and a new drag link would probably be easiest, but you may not have clearance for it. If you don't think...
How much lift do you have? Spring over or spring under?
I would also try and run TRE's instead of Heims. I had to run a Heim on my pitman arm for a while, and as mentioned, it was always loose. I also...
There's always Ebay :D...
Oh yeah, Detroits and 4:88's. the front will get better joints and alloy shafts later. Not in the budget right now.
And the new front Dana 44. It started as a Dodge. I narrowed the passenger side 5 inches to run a Wagonner long side shaft. WMS to WMS is right at...
Here's the latest addition to my Jeep I've been working on. It started as an F-150 rear that I cut 5 inches off of the passenger side. That let me...
Hah! I was checking that out on CL too, but the wife said NO! R) Good luck with it. Also, there was a guy in my local club,...
Bob, I don't think you want to see any of the slip splines while the Jeep is at rest. All the spline section should be completely in the slip...
Are you going to go fuel injected with your V6 swap? Something else to consider while you're swapping. And might as well do that P/S swap while...
I would pull the rear driveshaft just to be safe. I was told i could leave the rear shaft in mine and I believed it right up until the time it...
If you're talking about the rubber bumpstop, then no. It shouldn't be touching.
I know affordable fuel injection makes a bolt on kit as well. I think their kits run about $1k.
Quadratec sells a Flowcooler brand pump for the 225, but I think its the short one like you have. I have a new pump for the 231 that has a longer...
You can get a diff cover with a higher fill plug for this too.
Separate names with a comma.