1966 CJ5 - 225 Dauntless I realized yesterday I needed a new crankshaft pulley to complete my power steering conversion. I have not found just a...
While putting my axles back in the housing. I noticed that the wheel bearings don't sit as deep as I imagined they would. I remember them being...
Below is a link to the noise I hear when I press the clutch pedal in too much. It sounds alright when you press the clutch in a little. At about...
I have the 225 with Advanced Adapter to T90. I started a pile of parts that I am slowly turning into a jeep. I am looking for a parts list for the...
Loose front wheel studs on 10" drum breaks 66 CJ5. New Drums, Original Hub, New studs I had my old studs pressed out. They held the drum to the...
Working on the brake system this week on my 66 cj5. 10" drums on front and back. Single cylinder MC. Just bout a new master cylinder from kaiser...
I installed my T90 and D18 combo a few months back without a gasket between them. Today, while looking online for a gasket for the pto cover for...
I just bought new drums front and back and neither are fitting right. The front is a Dana 27 the new drum does not fit over the shoes. I tried a...
Today I tried to install my T90 and D18 combo today and it just wasn't happening. To start things off, I ordered a new Luk clutch kit with new...
Ok so I don't know what it is called but it's what the steering knuckles pivot on the axle housing. The question is how smooth does it need to be?...
I have found myself with a unused jeep body and a couple or rear axles. Has anyone made a trailer out of a CJ5 tub? I saw one made with the whole...
How do you tell the difference between a flanged and tapered d44 rear? There is one in good condition that I am going to look at this weekend....
My jeep never came with a tranny. Picked up a rebuilt T90 and D18 combo. Is there a specific cross member that i need? I know i need to drill...
I am just cracking open my SM420 tranny for inspection. From it shifted and spun in all gears when I got it. I have not done this before so what...
Just bit the bullet and bought a DUI distributor now I have some questions. First off, I have what i think to be the cylinder numbers in the...
Could someone please tell me what these parts are? 1 goes into the back of carb 2 goes into the air cleaner I need the gasket on the valve...
About to start wiring my dauntless back up. I have drawn up what I think it should be wired as. The only thing I don't know is how to wire up the...
What exactly is this crossmember called. All the replacements for rear crossmembers I have found are for the rear bumper. Any suggestions for a...
I am restoring my frame, just bought some POR-15 with chassis black top coat along with POR-15 Prep chemicals (Marine Clean and Metal Prep). I...
I have a Dana 44 offset in the rear. Dauntless 225. and Have reached a dilemma. I just bought a SM420 which mounts to the dauntless, I also have a...
Separate names with a comma.