Last time I looked on Herm The OverDrive Guys website, he mentioned used adapters. They really don’t wear out and it will save you some cash.
In our area all of the re capers are out of business. The was a shop that had snow tire tread very similar to a Firestone Town and Country
I used aluminum flashing and pop rivets to make the box. I was able to salvage the butterfly from the cardboard original that the mice and years...
Can’t believe he’s painting on a what looks a dirt floor. Even on my concrete garage floor , I wet down the floor to minimize kicking up dust....
I’m leaning towards sending the tranny to Herm. As much as I like the idea of doing it over myself , I really don’t want to remove it if I get it...
this is not a CJ specific post but is component related. How difficult is it to rebuild the t15 and d20 in our 69 j truck? The rational part of me...
I put 11” brakes on the front and it made a huge difference. What mods will have to ge done to the steering shaft if I take on the steering upgrade?
Not sure if I want to take the project on. There always seem to be collateral issues with these type of projects.
We rebuilt the Ross and it is about as good as new as possible. Did you buy the tie rods etc from Herm or on the open market? It seems that...
Today I ran into a local Jeep collector and our conversation was about Herms Ford Steering box upgrade. He said that’s a great upgrade. Never...
I know that this doesn’t directly affect CJs but we finally got to the bottom of the occasional soft peddle on the Gladiator. We found that when...
We installed a MC from J and W. I looks identical to the one we had from NAPA from a 76 Bronco.They said it would fit the the booster they sold us...
The f100 MC was not even close. There was no hole in the plunger for the push rod. The boys at NAPA gave me a MC from a early 70's F250. Its...
I did some research after my initial post and found out that I will have to remove the check valve. I was advised that a MC from an early 70s...
Doing this modification on my sons 69 gladiator. Does anyone know if I need to remove the check valve in the front mc reservoir? The mc is for a...
Where did you get it or should I say, whats it from?
I was told that there exists a mount specific to T98s. I also used spacers. I had a huge problem because I have a fiberglass body and everything...
I used a chop saw to cut the roll rubber. I stuck a dowel in the hole so my fingers were away from the blade. I also used some pieces of boat...
I have painted my CJ5 and my son's Gladiator with TCP Global's house brand with decent results. Their prices are very reasonable. In my experience...
I need to repair or replace the transmission mount on the T98 on my CJ55. The steel portion is pulling put of the bottom rubber, so the...
Separate names with a comma.