Hey there, I have couple questions about my stock cj 5 frame that maybe someone could answer. Is the frame made of a special hardened steel, and...
Hey gettin ready to drill the 4xfloor drain holes into my new floor and would like to know the size I need to drill to be the same as original....
Hey there, couple questions about brake upgrade to my 67” cj 5. I using 1974 cj hanging pedal assembly and maybe 74 column too pending on space. I...
[ATTACH]
Hey there, I’m just get ready to final get rid of my plywood and pl glue temp floors and could use some help on some tub measurements. - from top...
Hey there everyone... Maybe someone can given some insight to my drum situation. In jeep now is 1973 commando centre flanged d44 and stock 11"...
Hey there, should the gauge needle be about half when 231 v6 engine is warm, or full pegged reflects a hot running engine??? When engine is about...
Hey there... maybe a member has some insight to my issue? 1967 cj 5 231Ev with new 3222 fuel gauge and new non return fuel line 6 bolt sender for...
Hey there.. do both of these lamps in the speedo get there hot power source from I terminal of fuel gauge??? Thanks J
Hey there, Im in need of new gas gauge... will the replacement one part 1955-86 #3222 work with my 1967 cj 5 in gas tank sender unit? Thanks...
Hey there, im just finishing up on sm420/d20, the stock cable is no longer the proper length! Funny enough though, the stock cable will bolt up to...
Hey there everyone Im just finishing up 2.5 BDS lift and a sm420/d20 to centered d44 diff... couple questions on drive shaft angles and whats...
Hey there, I just finished sm420/d20 swap! The guy I bought the trans/t case had painted it and sm420 shifter knob tremcald blue! Weird... Anyways...
Hey there everyone, finally gettn around to sm 420/dana 20 swap....So jeep is v6 with small 1210 york ends on stock FRONT drive shaft and new dana...
Hey there, I'm now having a clutch issue of no engagement! I was running the jeep with just the rolling frame with 231ef/ 225 flywheel and...
Hey everyone, I could use some advice on my 1968 electric top mounted 2 speed bosch wipers, Im sure they are the stock wiper motors. I rewired...
Hey there guys got all the old ccts sorted and lights run on jeep! I just cant find a 3 pin old elctromagnetic style flasher at parts place! I...
Hey there everyone. I m doing another 231 swap and getting pretty good at it..a couple hours re-and re engines. Anyways this most recent donor...
Hey there, I'm get ready to shorten front/rear dana 44 out of a scout, I have a couple questions!!! I know on the scout front I'll have to rotate...
Hey there, i have a question or two about MD Juan/Omixada replacement front floor.... Ya the really expensive one!!! I would like to put a floor...
Separate names with a comma.