Pulled the 67 Jeepster out of storage a couple weeks ago. It has been sitting for about 5 years or so. It started right up after I filled the tank...
It's been awhile since I have been here! The old CJ5 keeps rolling, the CJ7 works well, and the new addition to the Jeep fleet is my daily...
The last year or so I have neglected the CJ5 and Jeepster to build a diesel Grand Cherokee. It is getting close to finished and hope to have on...
The 1966 V6 CJ5 runs out of fuel when I run it in any gear near 2500 rpm, as I slow down it will begin to come back, or if I push in the clutch it...
Think I need to replace this, funny thing there was still grease in the cavity. On the way home today from a local car show the bearing...
Where do the twin sticks come through the floorboards? Is it the small plate to the right of the transmission, or do I have to cut a new hole?...
Here is a photo of a BW OD on a Dana 18 TC. Unusual set up.
I picked up a twin stick case cheaply last year, but it appears the shifter pivot shaft bolt head is broken. I assume this is a special bolt. If I...
Re: Over drives for dana 18 Not to highjack this thread, but could the B/W OD be adapted to a Dana 20 in something like a Jeepster? Or is there...
Tried to start the Jeepster today to move over to the other garage bay and it would not start. It started with gas poured down carb. Added gas to...
Took the transmission cover off today and found the rollpin fell out of the R-1 shift fork and the 2-3 shift fork roll pin was loose and cracked....
So I take the CJ for another test drive to town about 8 miles. Gas gauge is at 1/3 - close to 1/2 tank. New guage and sender. Figure must be ok, I...
There is a story on the Midwest Willys Reunion in the October issue of Vintage Truck Magazine. There are 5 photos of Jeepsters, mine is only in...
Is the intake, fuel injection system, and exhaust manifolds, from a 1990 GM 3.8L V6 front wheel driver, compatible with the 225 V6. Could I use...
I need to change the valve seals on my CJs V6. I am doing this without removing the head. I have an adapter for the spark plug hole for...
Should I be able to turn the cable and make the needle move? I installed a new cable and cannot turn it. The old one was twisted off at the TC....
I would like to have the oil pressure light in my dash work, redundant system, and I liek that something orginal works. I can not tell from the...
I am in the process of rewiring the 1966 CJ5. Which side of the fuel gauge is the positive and which gets the signal? The terminal close to the...
I am looking for help on placement of the cage in my CJ5. I have tacked the spreader bars inline with the org. equipment rollbar, but they appear...
Separate names with a comma.