I've had 3 73's with V8s Yours don't look bad at all. You will get plenty of help here for anything you want to do to the thing. Your last pic...
Get a flaring too...even a cheap one and about 4 feet of scrap brake line....PRACTICE, PRACTICE, PRACTICE.
Just finished wiring a building for a network and for phones. Over 1600 8 conductor cables. Wiring is not hard...One at a time with lablels
Thanks. It looks easier to do it that way rather than fighting with it in the Jeep.
When I busted a timing gear a couple of years ago in my Dauntless, I fixed it in a parking lot and used a lot of RVT sealant. It worked well till...
Never done it but you should be able to hook up a battery and starter to turn the engine over. That's all you need to check compression.
I agree it's snake oil. The purpose of the pcv system is to do what this device claims to do. It goes inline with the pcv line and as far as I...
Yep...Mine has 10 inches and is proud of every one. I would make the Jeep safe with the above advice, drive it for a while to determine how you...
Being an old telephone man we used lead to "wipe" the splice cases for our cable. Of course our splice cases were made of lead but the basic...
Re: V6 Cutting out at cruising speeds? When I installed my HEI I had to advance the timing to something like 40* before TDC. Could this be the...
Re: V6 Cutting out at cruising speeds? I had the same thing happen with a Chrysler K-car way back when. Probably not the same cause but my...
The 225 should be set at 5 degrees before TDC. if I remember right
I like your idea of staying with Jeep power Rat. For some reason it just seems right. BTW, Thank you for serving our country. Most of us...
I ran a pertronics for a while in my '66 225. It was like night and day difference. My main concern was I didn't know how reliable it would be....
Ok, According to my 1966 owners manual on page 6 it says the following: Gross Vehicle weight...... 3750 Shipping weight......2163 Curb...
Welcome from down the road in Newport News. Since you are new at jeeping, I'd take it slow for a while and enjoy tinkering and driving your...
Very easy to reclock a distributer. Plenty of help here if you run into problems.
Basicly the same thing happened to me a couple of years ago. Turned out to be a broken timing gear. Good luck.
I would think twice about drilling finned drums. The fins were put there to help dissapate heat and although drilling should help, I would be...
I run 31x10.5 on my '66 with stock suspension with no problems. I went to the York show a couple of years ago and had a great time. Found a...
Separate names with a comma.