Finally got it towed to work (where I had tools)...and it started, and didn't even cut off. Thing is, it was running REALLY rough and losing a...
So I got it started. Ran about 15 minutes but it's sputtering badly. Added a water remover and some fuel cleaner additive. Running like ****...
Fuel line is nowhere near the exhaust. It started again today but only ran for a few seconds. Altitude is equivalent to my old station and the gas...
The fuel sending unit is already disconnected since it isn't working. I'm kind of handicapped bc I just moved and don't have my tools yet; it's...
I did look at the filter last night and it looked fine. I shined my iPhone light in the tank, but it was hard to get a good look at the gas. My...
Ok thanks. Piffey do you mean with the engine off?
Btw after it was towed it started again and ran for about 5 seconds cutting off...
Odd fire 225. Fuel squirting into the carb...can you elaborate? It was hard to get a good investigation since it was getting dark and I was on a...
I shipped my CJ-5 across country, picked it up, and filled it with gas. Five minutes later I'm on a busy San Diego freeway when I had to pull onto...
I just installed disc brakes on the front axle, as well as a new master cylinder (and a few of the lines). After putting everything on and trying...
I tried to straighten the cage...I couldn't get it back to its original perfect shape.
In my newb genius, I left the wheel bearing in the hub/rotor while putting the new rotors on, and the outer one fell out and got bent on the...
[Sorry for the newb questions...this is my first time going this in-depth on the axles...] So the axle shafts are installed, along with the...
Thanks; it is hard to describe. I couldn't find a video to be sure, and the seal will go in either way (btw by "hammering" I meant lightly tapping...
By convex I meant the part with the curve facing out. So you're saying that basically I'll be hammering on the curve of the seal, not the thin lip?
I'm assuming the seal goes in so that the convex side faces the bearing? It doesn't specify but that seems to make sense.
I also found it odd that I don't have any bushings like the pic shows; were these not part of the setup every year?
I'm switching my front Dana 27 axle to discs using a kit from RP4WD. I've removed all the old components, cleaned everything up, replaced all the...
The salesman said I would not need a proportioning valve unless I'm doing a lot of steep offloading. I meant to refer to the residual check...
I'm overhauling my brakes...here's the issue. I keep losing fluid, but I can't find where. After noticing a dry master cylinder (with a bit of...
Separate names with a comma.