i got mine from willeys overlander and they had one in stock, it shiped in 3-4 days.
Thanks alot those pics were great, you guys gave me some ideas to get me going. Keith
Thanks Eric I looked at that web site and i did find what they called lower floor supports. I will call them and see if they can help. So again...
Does any body have any suggestions to help me out. I have a 68 cj-5 that on the drivers side the channeling in between the tub and frame is rusted...
thanks for the info.today i went out and was fooling around with it and thought that maybe the bearing was against the presure plate and pushed...
in the tacoma washington area they want 350.00 to recore the closest i found was a 64 or 65 ford gallaxie rad was the closest i think both top and...
no travel before the cable was hooked up. all parts were same size that came out. this weekend i'll remove boot and try to look and see if...
this past weekend i swapped motors in the cj5 and replaced the clutch, it all went smooth execpt when i went to reinstall clutch cable the fork...
I think the ones at jeepdoc are for 72-86 v-6 which has diff dimentions that the 66-71. the only place ive seen them new is at four wheel drive...
I to am in the same boat with the rad problems. The local shop wants 350.00 to recore i talked with radiator.com today and found that closest rad...
thanks guys any idea where to look for 3" on those back spacers
I would like to put a set of swamper tsl 35x12.5x15 on my 68 cj5. My question is a 4" susp. lift and 1.25" wheel spacer going to be enough or am i...
I trying to find out which buick v6 engine is preffered. I understand they have two, od or even fire. I'm putting it in a 54 m38a1
I'm trying to come up with one jeep combining the two. I'm not sure that the older front axle is a 30, I was told that it was. How can you tell...
i have a 79 postal jeep with 258 etc. I just bought a 1954 m38A1. The m38 is in real good shape but no motor. I am thinking about combining the...
ok I have a 54 m38 a1, what would be the best, easiest engine swap to do. also easy on the pocket book
the reason for the 258 is I have a rebuilt one already.
I have a 1954 m38a1. I want to put a 258 in line six into it. I have been told this is major project. I have a T19 trans. I also have the front...
Have any of you guys used a luk clutch, and if so what are your thoughts? I know centerforce has a good name but they are spendy.I've got a 68 cj5...
Thanks for the input I called them and they said it was a custom job and would get back to me on monday with a price.
Separate names with a comma.