OK, I know it is not a true roll bar. But, I'd feel safer with it on than off. It seems that I have a lot of leeway in where I punch holes...
OK, I have shortened the link from the clutch fork to the arm about as far as I can go... And, the clutch (new) still does not disengage. Where...
I have now realized that the "new" flywheel that I installed quite a while ago, is a 124 and not the 129 tooth ring gear. The beast is all...
When I got my engine back from a local overhaul, I added my rebuild T-90 with new clutch and ring gear on fly wheel (old one had a bad spot chewed...
As I am reassembling my '59 CJ5, I redid all of the electricals. Had the generator and starter rebuilt at a local auto electrical shop. (Yes,...
I started in September 2003 - I figured it would take a year. Still not on the road, but I have promised to have it done in April (no year...
Decided to clean up the old (under seat) gas tank. It was dipped at a local radiator shop (who advised me to trash the radiator) and I had let it...
Rather than hijack the previous thread, I would like to know about the F134 position for (1) The pressure sender (the pressure switch that light...
I disassembled this so long ago, I do not remember (and did not photograph) the sequence of hardware that attaches the grill (and radiator) to the...
I am trying to diagnose the turn signals for a '59 CJ5 with all new wiring. (You should have seen the stuff that was in it when I got it!) Is...
Rebuilding 1959 CJ5 F134 - From a parts jeep, I have a dual cylinder conversion kit from ATV (Herm). I am at the "dry fit" stage and find that...
Any suggestions on cleaning up the original Serial Number plate? The lettering is worn to the aluminum, background is a stylish mix of grime,...
Does the kit for an M38A1 fit a '59 CJ5? I bought a parts jeep (the M38A1) since it had several upgrades that I could use on the '59 that I am...
Can (should) the upper part of the Oil Bath Air Filter be dissassembled for cleaning/repair. The fitting for the crankcase hose is very loose....
Three years after disassebly, I find that I did not take enough pictures. (What a surprise!) As I plug the various empty holes in the dash, I...
After having all of my body parts repainted, I find that I did not take enough pictures before disassembly. I have found a source for new wirng...
I have just got all the parts back from my painter. Here is a sample of the Before and After effects. [IMG] Also looking for suggestions to...
When I got my '59 CJ5, there were clear glass lens on the front turn signal lights. And, there were two, not matching, clear glass lens light...
I'm looking for a source for the little clip that grabs the spark plug wires over the valve cover. I have the "Z" bracket, but not the clip that...
My project 1959 CJ5 did not come with a stock horn. The horn that it came with (and the other antique horn that I have) is a single contact horn....
Separate names with a comma.