Oops, I guess I forgot to mention that this is a two barrel carb, sitting on a Buick 232 engine. I bet that makes a difference. Sorry, important...
I didn't even know that was a thing. Would replacing this particular part require a carbarator rebuild?
I knew this would happen. The 'Ol girl heard me talking about selling her off, so of course she starts acting up. Here is the deal. The jeep...
Well, here I am again. After wheeling her a couple of weekends ago (nice seeing you again Dave, and JC is amazing to watch). I decided that this...
Anything I need to know? I have a diagram with all the circuits (and potential future circuits). Looks like I can just have one built to order...
"Usally you know there is a oil pressure problem when cold you have some pressure. Then when it gets hot and you come to a stop, the pressure...
Uhh...just how difficult is it to replace the oil pump Buick 3.8 liter? Not that I have too yet....but, I seem to have some oil pressure...
I'm confused. When it is warm out, the Jeep doesn't drip and antifreeze. If I overfill it and drive around, it will "puke" out a little bit, but...
Just because I want something to think about...here is a question for everyone. I have 5:38 gears in my A1, T90/18 transmission/case, and 31"...
Sorry, haven't been to the site in a couple of weeks. Thanks for the compliment! The rims are 15x8 and the tires are BFG Mud Terrain (not the...
I'll keep that in mind, thanks for the suggestion. Of course, it is too hot out to even think about playing with the Jeep....I guess I'll have to...
What can you do with this friends thing?
I'll probably just use bolts to put it all back together. I can't get the studs out of the old water pump without messing up the threads. The...
I think the previous owner used the longer studs to bring the fan closer to the radiator. There were 5 washers stacked up on the end of the stud...
is their a particular reason I should use these type of fasteners on the water pump, pulley and fan assembly? Can I just use a straight set of...
Thanks for the information. I ended up going to Rose Motor here in town (they specialize in older/rare stuff) and they found a water pump that...
Water pump started making scary sounds last weekend on my '53 M38a1. I could see the pulley wobbling around when the engine was running....
53 M38a1 frame and tub and hood, replacment fenders, Buick 231 engine (I just tell them 1985 3.8 Regal and it usually gets it), master cylinder...
I replaced my ignition last night (the little thing that you put the key in to turn in order to start the Jeep). I just used a generic...
Well, I just recently rebuilt my T90/D18 with the help of Sparky and the follow along directions I found around here somewhere. I won't say that...
Separate names with a comma.