Can anyone tell me the height, from the floorboard to the bottom of the seat frame (front of the seat} on an M-38? Thank you, Jordan
I have a civilianized M-38 and want to install aftermarket bucket style seats in the front. Has anyone found an aftermarket bucket style seat...
What is the fuel line diameter on a CJ3a or M-38? Thanks, Jordan
Do I need to use teflon tape when screwing brass fuel fittings into fuel pump and carburetor?? Thanks, Jordan
What is the wheel bolt pattern on a CJ3a? Is it 4.5 x 5??? Stupid question, I know. Thanks, Jordan
You guys who have done a Saginaw conversion in a vintage flat fender, are you changing the steering column angle at all? I have a tilt column,...
Must roll cage be bolted to the frame in order to protect in a roll-over? I am going to build a cage for my civilianized M-38. I'll have...
How are you guys booting your twin sticks coming through the floor? I've got an aftermarket boot with the hold down ring, but its not gonna work...
Can anyone provide me photos of their Saginaw conversion for a CJ2a, CJ3a, or M-38? Specifically, I need a photo of the steering column coming...
Are you guys putting seat belts in your old flat fenders?? If so, any tips or tricks on what to use and installation? Thanks, Jordan
Is there supposed to be a heat shield between the exhaust pipe and the brake master cylinder on these old flat fenders? The exhaust pipe runs...
Can any of you gentlemen give me a measurement from the top of the driver's side seat frame down to the bed (behind the seat) on an M-38 or CJ-3a...
Can anyone recommend a steering column to use in my civilianized M-38? I have a sagninaw manual box and I need to try and marry it up with a...
Any thoughts on the wisdom of installing a lock-right in the Dana 25 of my M-38? Being an older guy (and thus having reduced testosterone levels...
Gentlemen: I have a Dana 25 powr-lok gear set in a Dana 27 powr-lok carrier/case with an adapter plate from Herm the Overdrive guy (I guess the...
Has anyone shaved the head of the L-134 to try and boost compression and horsepower? If you've tried it, or knkow anything about it, I would be...
Any advise on leaf springs for a soft ride (relatively speaking) for a vintage flatty? Thanks, Jordan
Can anyone give me a comparison of ride quality with the Superlift springs with the 2.5" built-in lift as compared to the stock military springs?...
I have a 3.5" x 2." rectangular tube steel bumper bolted to the frame horns of my civilianized M-38. In the middle of the bumper span (between...
Just bought some 19 spline rear axles and Warn hubs from Herm Tilford (Herm the Overdrive Guy) for installation in the rear axle of my M-38. It...
Separate names with a comma.