Doesn't matter if it's a 1 car garage or a 40x60 shop like mine. There is never enough room.
Gonna lay low on this one since I've been banned from 2 different forums cause they don't have a photochop sense of humor.:D
Stretch it!! I'm stretching mine but in the area of where you step through. I like the top one
True it is a scratch. 3/4 long, down about a 1/16 but I tell you it's d..n sore this morning. The end of the tool is blunt before the edge starts....
Should be worn when using deburring tools or any other sharp object. [IMG]
Just to add get the activator for the 3M tape also. It will make it stick even better.
That gonna work for you?
We have a 51 jeep here at work that gets towed everywhere. We just put the transfer case in neutral. Now in the 20 years I have been here I have...
1" [IMG]
You can shove it in at any position you want but remember if the caps are marked with a 1 it kinda sucks when you have a different plug wire on...
What was CO at idle?
Not really. You have to weld in a bung and then use a plug if you don't leave it in. Using then them at the tailpipe is inefficient. The only...
It's the same here but if it takes 5 minutes to adjust a screw they will do it rather than fail the vehicle, quote him, charge him a minimum and...
Ya but this whole emission testing is out of hand. All they do is test, fail, give you an enormous quote on repairs, retest, pass. Any good honest...
It's to lean. Richen it up to bring the HC down. My smog guys will take the time to adjust the carb rather than wasting their and the customers time.
Depends on the generator but if the welder pulls no more than 20 amps I'm gonna say yes.
Since the left side is slotted I measure 14 3/8 - 15 1/8"
Ya. Among other things.
I was running standard adjustable lifters with a 290 @.050 with .650 lift cam. It wasn't until I broke .700 lift I went to roller parts in this....
I ran rollers in my fishing boat but then again I was turning 7000rpm. For a jeep I don't really think its necessary unless you are run big cams...
Separate names with a comma.