The toyota starter only works with the 129 tooth ring gear which is the right diameter for the teeth to mesh, you have to egg out the bolt holes...
Got a 73-76 something corbled jeep they put a fiberglass tub on it and never transfered the parking brake stuff, just cut off the cables at the...
I run 10w40 in my engine and it's a simple trans and rearends any 80-90 or 85-120 wt gear oil will work, there made much better than when your...
did you put a new codenser in, the old boy's always said if it ain't bad don't change it. I always did and I had a bad one right from the git go once.
Put in my request thanks alot.
Where can a guy get a new vin tag for a 73 Cj5, mine is half rotted away and impossible to read?
Anybody got a part no. for a y-pipe, Buick odd fire, drivers side straight down and passenger side 45 degrees toward the back exiting towards the...
Midwest Military Jeep Parts has complete heater kits, ductwork and all $325 can be found on page 11
Originally the vin of the F134 was stamped at the front of the block under the water pump and can't be stamped after assembly. Thats where you get...
All I want to say is stamp your VIN numbers back on the block before you put it together or you won't bee able to, thats the way it came new.
If you haven't broken any studs on the down pipe oops should be only one heat up the nut after cleaning all the rust off the exposed threads and...
You want to see some goo, I didn't understand the air flow on my A1 and tried to make it go backwards, doesn't work. I would say check the PCV...
What does the engine stay cable actually do? I forgot to put mine back in and haven't noticed any difference, didn't know I forgot it till I...
Pull 50 or so over the hills- 50 is the fastest I want to go in an A1 any faster and i'd have to clean my pants out.
broke two off on the motor I'm trying to make leak free to replace the other leaker in my A1. I put a washer over the stud and welded the stud to...
I tried running it with the flywheel in both positions and it doesn't make any difference on the vibration. I need to replace both front and rear...
I marked it but noticed that it has probably been off more than once and wanted to be sure it is right.
i've got my flywheel of to replace the ringgear, is there a certain way the flywheel and dowl pins are timed all my liturature only says instal...
Anybody got a list of starters that fit an F134 motor?
Well I've got the new rims and tires now i need to do the suspention seeing it is the original 12 leaf thin spring setup sagging quite a bit on...
Separate names with a comma.