OK, this might not be your standard fab question, but it didn't seem to fit in any of the other forums either, so here goes... I am looking for a...
I've got a 43 Willys that has what I think is the stock tranny. The shifter handle is real loose, making it hard to find the gears... otherwise...
So here we go. Why spend time on a good back up light? I have went through a lot of money over the years on driving/fog lights. I always seem...
I know I have seen something on this here, did a search (couple), no luck... I am building a waggie dana 44 front, using Chevy backing plates,...
I'm working feverishly to finish my CJ-7 (rear dana 44/ox locker, front dana 44 detroit 4.56s, dana 300 4to1, NV3550, hydraulic clutch, new...
I am selling a hood prop rod from a CJ7 on ebay, and the question came up... I bet it could be made to work, but I am thinking 76 was the first...
I scored a set of the original Jeep Renegade style alloy wheels off ebay. My question is what type of lugnut do these use? For some reason...
I found the "jeep in a pasture". Not sure if it is actually for sale, but stopped and looked. Ramsey 8000 pto winch with pto and driveshaft, 2...
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7981370747&category=43955&sspagename=WDVW I was looking at these, and gave...
Has anyone ever intergrated a receiver hitch into the rear crossmember where the stock pintle hook location is?? I am thinking one could cut a...
My HEI mech timing weights are giving me headaches with erratic timing problems. Thinking of changing over to a locked out dist and using a MSD...
Check out my custom built stainless dash. CJ style made to be bolted to a YJ tub. I had them press three extra studs into the bottom flange...
I am fooling with the idea of mounting a small fuel tank under my M416 trailer, and using an electric pump to move it from the trailer to my...
As some may know, I spun 2 rod bearings getting on it a couple weeks ago. Motor is out and new (to me) short block is on hand. My question is...
Not sure if this is the right place.... Some may know that I got a little carried away during my last off road trip, and the results are in:...
Here is my new longer and properly cuved e brake arm. The original came on my park brake assembly which came from Ebay some years ago. Mine was...
Not sure if this goes in the Fab forum or restoration.... Had my 16x5 kelsey hayes rims sand blasted.............. One had some pretty good...
Even the most original, untouched Jeeps I have seen are usualy missing the Hall taillights. Why do you think this is? Did they rust out...
http://www.4plusoffroad.com/custom.asp?id=31494&page=5 Anyone did this?
I am thinking of adding one. Would be interested to see how somebody else did it. I have seen some aluminum ones on ebay (tall and skinny) that...
Separate names with a comma.