I just got it running the other day, after sitting for a few years. I haven't gotten too far into it, since I bought it for my daughter's 14th...
Well, this should be interesting. I've begun the swap from the t150, 3 spd in my '77 CJ5, to a NP 435. I have the trans and t-case out as well as...
Only got the passenger side done, but like the changes I've made. Hope to get the other one done in the next week, when work allows. This is on my...
I finally got to spend a little time, working on Odie, the past two weekends. I got the old, home made crossmember cut out, removed the factory...
... for the Ross bellcrank to be riveted and welded to the crossmember? Just wondering if I should be cursing a PO or the factory. I will give...
I'd rather have gotten single outlet but these were a deal I couldn't pass up. After adding some thickness to the flanges (they were only 1/4"),...
I've got my '67 stripped almost to the frame. Before I get it completely bare, I need to figure out exactly how to procede. The frame only has...
I got the '71 Commando running the other day. Driving it off the trailer and around the yard showed a problem, though. The tranny seems to have...
I've been looking at a replacement harness in the Quadratec (or was it 4WD Hardware?), made by Omix-Ada. It's listed as a direct replacement for...
One of the biggest things keeping me from using my '67 is that the rear end is trashed. The housing is good, but everything inside is turned to...
... You use a rear axle with a centered diff with the offset D18 t-case? My D44 is trashed and it seems I can get another axle for much cheaper...
Separate names with a comma.