I just upgraded to a new internally regulated alternator (three wire). Problem is I'm now having issues with my plow. I've got a e47 Meyers. When...
I've been going over searched threads for a couple of days now and haven't found what I'm looking for... I am looking at replacing my alternator...
Just finished some repairs and some modifications to my "6". Talk about project creep, I think I fell victim. I started out wanting to replace...
OK, I finished up the saginaw power steering on my '6'. Wrapped up all the loose ends, filled the pump and followed the suggestions for priming I...
Anyone have a good method for a do it yourself wheel alignment. I've done the method listed on the old Vernco sight with the lego and string in...
I'm having some issues with my steering conversion. I'm trying to covert my CJ from Ross steering to Saginaw. I'm doing a 2 hole, single tie rod...
Started the saginaw power steering conversion on my '6' today. Along with the PS I'm adding a two hole passenger side knuckle and flip the tie...
Well, last week I plowed the driveway for the first and only time this year and today I notice a large puddle of gear oil under the 6. Hard to...
When adjusting my :v6: timing I've got it to where it seems to be running pretty strong. Last weekend I took it to the cabin and after about a...
Last year I replaced the springs on my CJ-6. Since then the rear springs have settled a little, as I expected they would. In doing so my Jeep now...
Can anyone tell me the hwy difference in Shifting levers on the V-6 JEEPs. I've seen Dauntless JEEPs, all with the T-86aa, with straight shifting...
Can anybody with the 15x8 KH rims tell me if the rim will allow a moon type hub cap (like the original Kaiser hub/center caps) to be attached? I...
I've decided to try the petronix ignition and I was wondering if is it necessary to replace the stock coil with a upgraded coil like the flame...
I know this topic has been covered....but, has anyone used POR 15 to seal a gas tank? I saw POR 15 has an actual kit to seal a tank, but I was...
Finishing the knuckles on my D27, followed the FSM supplemented with Vernco's write-up. I checked the knuckles with a fish scale before putting...
I was looking over the Project Hatari article (link form Boyinks website) and was wondering... I was looking at the rim and tire selection that...
OK, Temp guage wasn't working (would move off 'c' a little and no further) so I started to diagnos the problem. Started by trying to ground the...
In regards to the T/C E-Brake return spring, where does it contect to? It attaches to the clip (clevis and arm area), but from there were does it...
Anyone use POR 15 engine enamel on their :v6: ? I got some Buick Turquoise and its way too dark looking. Anyone have this problem or am I the...
Hey, just thought I'd make mention. I just got an order from Walcks 4WD and there was a flyer with reporduction Hall tail lights listed. I was...
Separate names with a comma.