The way I registered mine was by getting an independent Vin verifier. The person came to my place, looked at the jeep, and signed the necessary...
I did my own brake lines from scratch and I'll second using a good quality flaring tool. The best part about being able to cut your own lengths...
so far so good! so far it's only been cleaning up connections and replacing one of the undersized ring connector on the solenoid from the...
I got the starter tested and it's still good. Seems to narrow it down to heat (exhaust manifold is about an inch away from the solenoid) and...
I'll be checking the connections next... Finally have the chance to start looking into this...day off today. I did the test that Tim...
Thanks for the replies...Not sure if my description of "half a crank" made any sense but glad you guys understood. Basically, the starter engages...
I've been having problems with starting when the engine is hot. It happened again just now, I make a quick stop at a store, maybe 5-10 minutes,...
Can the mirrors in this kit go on either side? or are they side specific? [img] I'm trying to install a mirror on the passenger side and I...
I used 3/16 plate for the boxing. I only strapped on the bottom side around the front and rear frame horns...it seems to me that only strapping...
I mounted mine based on Dummy's article in JP. When unloaded, the shackle is perpendicular to the ground. When loaded, the shackle moved approx....
[IMG]
was looking at the gen-right website and it said their 3/16" corner guards weighed 40 lbs each when uncut...they also have 3/16" aluminum but it's...
From what I've read here, thaat's how it was done at the dealership......
how much larger? I remember thinking the same when I installed the pilot bushing on mine, but it eventually ended up working out. As I was...
in addition, the rear hatch has a little bit of adjustability also.
I'm using '78 gas tank and skidplate on mine. I have the skidplate bolted on the crossmembers. The rear crossmember has been replaced with a 2x4...
you can... http://extremecustomparts.com/i-1706567-cj-willys-jeep-rear-roll-cage-add-on-cj5-cj7.html
got a link?
I narrowed the stock crossmember that came with it. This places the transmission way up. Notice the cut on the floor support at the yoke. I've...
Here's some info from Mr. N http://77cj.littlekeylime.com/Dana44_3.htm#Chevy
Separate names with a comma.