[IMG]
They look like whitewall rings to me since they go right up to the edge of the bead. You can get them for around 70 bucks or so. [IMG]
No rubbing at all so in that aspect they fit perfectly. I don't think they are any taller than military NDTs but I would personally prefer a...
They are National Commando 215/85/16. Wheels are stock for a '59, I don't recall the width.
Mine are 16" and the skinniest ones I could find that would fit were 215/85's. They are over 30" tall -- too tall in my opinion. I think they...
If this hasn't happened to anyone else then it is most certainly my own fault. I'm guessing I didn't tighten them when I put it together. I did...
The last time I drove my Jeep, I noticed the front driver's side brake drum grabbing and it was progressively getting worse as the day went on. I...
I had an electric one that bit the dust and then "upgraded" to gas. I bought a cheap Troy-Bilt from Lowes. What a mistake! It is the most...
What about an old Mopar Slant 6? Talk about an indestructible engine. Not sure how obtainable they are but I remember giving one away many years...
I would stick with the original Carter if at all possible. I rebuilt my original a couple of times and still couldn't get it to run right. I...
As a Mopar fan, I think doing a 318 or 360 swap would be way cool. I've owned vehicles with both motors and they are great. I once knew a guy...
(y)
I completely rebuilt my engine, including having the head machined and the block tanked. Assembled everything per spec and used Plasti-gauge to...
If Rotella contains zinc. The guy at the machine shop who worked on my engine recommended either/or. I bought a case of the Zddp on Amazon and...
I run regular 10W-30 with a zinc additive, ZddpPlus. But diesel oil will get you the same results. The zinc is critical, without it you will end...
I was going to buy the MVP but cheaped out. I may regret it some day but for the type of welding I do, 110 volts is enough.
Well, got a tank of gas and hooked it up -- and I remembered to change the polarity, thanks Mark. Wow, what a difference! With some practice, I...
Nice Jeep. Worth restoring!
That's the one. I just tried it out by welding two pieces of scrap metal together. Love it! Even I can weld with this thing. I've never welded...
Bought a new MIG welder. I went with the Hobart 140 based on on-line reviews. I'm going to practice with flux welding before stepping up to gas....
Separate names with a comma.