What is the least time-consuming way to install the setscrew that holds the sliding-gear's shift-fork to the high-low shift-rod? Is a nearly...
A package from Herm to me with 29 tooth 10 spline overdrive parts was not complete, missing the barrel gear (the planetary gearset). The...
I've been following the Willystech.com rebuild guide; I am at step A20 (setting...
I don't know where to start on figuring this out. Hopefully someone just has general amazing-ness and knows... I have a gearset for a 30 tooth...
My parking brake cable snapped just below the metal ball within the handle. Is this something that can be repaired or using locally sourced parts...
On a very low level, how does an OD create the gear reduction? Here's what I've determined so far, please correct me. I've read that the...
I'm trying to locate information about a particular type of rollbar so I can find one/buy it. I've seen a couple guys around (cj3bpage and here)...
Has anyone messed about with putting beadlocks onto 16" steel rims? Split type combat rims apparently had a way to lock the bead. But I can't...
Does anyone happen to have details about the 10 spline Dana 18 Input shaft or gear? (Novak says it was used from '68-71 behind the Buick V6s)....
I'm posting this as a big THANK YOU for all of you who've given me help on various things, like the brakes, hubs, diff covers, horribly detailed...
I have a 50mm ammo can that I'm about to install for in-between-seat storage. I may be a dreamer, but I eventually intend to have both an...
Does anybody use skid plates on their Dana 25 or 27 differential housings? Did you fab it yourself or were you able to find it off the shelf? I...
I had never heard of anything but Mitsubishi 3B production. Perhaps it's a US production but someone put an early Mitsu speedometer in this? Early...
How much space should there be between new pads and a new rotor? I mocked up my disc brake swap and my inner pad touches the rotor. Rotor does...
Disc Brake Swap: Parts list, hub/bearing/race combo, Pictorial Note: If you are considering doing this, the result will be incompatible with...
On a 3B, how much room does the tie rod joint [that meets with the steering knuckle] need around it to move appropriately and safely? I'm doing...
I have a set of 10" Wagners with self adjusting hardware from a '69 Commando. They came to me with the adjuster pivot (the tab that screws onto...
I can't seem to find hardware for 10" brakes off a '66 CJ-5 (both came from the front axle of the same jeep). The springs don't match up in the...
I read somewhere that a CJ-5 fuel tank can bolt underneath in the rear of a 3B with little modification. I presume they were talking about 5s with...
My J54 came with a nondirectional spare, 7.60-15, on a 15x5.5 wheel (wagon wheel design):[IMG] Are 15"x5.5" wheels common? I can't find anything...
Separate names with a comma.