RGR thx it stays
haven't pulled this jeep down yet> but your right it is close. ok I will change it. I like tims Idea
Correction, Not preload, but end play. without the spacer i may not be able to get proper end play
[ATTACH]
Ok, stumped a little here. going through the Spicer 20 TC, It has obviously been opened up before. there is a spacer on the front output shaft...
they are definitely for the heater box, there are 1/4-20 studs that come out of the back of the box and pass through the fire wall bulkhead in...
Thank you Tim: I would still be fabricating the other brackets had you not spurred on the measuring of the bell housings. [ATTACH]
Im not to disappointed that the hole patterns do not match, it drops the Transmission another 1/4 inch [ATTACH]
Ok well: I spent four days fabricating brackets i did not need. The set up from Novak fits up with the D-20 adapter plate directly over the cross...
OK so the distance from the motor mounts to the transmission mount should be the same as the stock T-14 ? that puts the transmission mount over...
was not able to find a new flasher/hazard lamp when i did this dash, so I took the lens out of the old one and put it in a new body, at the time...
The T-14 Bell Housing is 8" from the front face to the back face, The housing that Noavak put on the t-18 is 7",,,, the pic is deceiving because i...
Separate names with a comma.