I found this in the back of my shop in the scrap yard connected to a transmission. [IMG]
It's been a long time since I've come around these parts, I've been learning in my short 25 years of life that life has a funny way of taking you...
For those of yall who don't run a heater system, what are yall doing for the cowl vent? I was thinking about just putting a a piece of sheet steel...
I'm looking for ideas on how to build my rocker rails. Right now I'm thinking a two-piece design; a piece of angle that bolts straight over the...
Out of all the options I've seen, I think this method requires the least amount of fabrication and retains a sort of stock appearance. [IMG] [IMG]...
Does anybody know if the metallic paints from the factory were single stage or bc/cc? Also, can somebody fill me in on what 'poly' means,...
I'm thinking about adding an under-seat fuel tank to my '72. What would need to be changed, other than adding the fuel filler housing? Are the...
I am considering two options for what to make my hat channels out of. I was thinking about either bending up a set out of 14ga. with a metal brake...
Has anybody come up with any good replacement solutions to rusted out cowl supports other than buying repros? Any pictures?
I was wondering if my rear springs possibly being backwards could have something to do with my flat pinion angle and distance between transfer...
I searched but couldn't find this anywhere. Maybe it's because its common knowledge. This is the first clutch I've ever had to replace. I have...
I won. They hit my stinger bumper. Buuut... my lower control arm-to-axle mount folded over on itself. So now is a good time to build that...
I'm rebuilding my 304, have the cam, crank and all the pistons installed with new bearings and rings. When I flipped it over to torque the...
Do I need to use the paper gasket in between the flange and the hub on my dana 30 or will RTV be fine?
Bet y'all thought I gave up, huh. So I started back in October 2010 by picking up this CJ5 just south of Raleigh NC. [IMG] [IMG] [IMG] [IMG] [IMG]...
I boxed in the front part of my frame and I'm about to weld in some sleeves for the bolts but I want to know what y'all think first. [IMG]...
I'm trying to remove the spindle thrust washer, the one that sits inside the outer bore on the axle flange. Its in there pretty tight, how have...
Has anybody powder coated their headers or manifolds? If so how well has it held up?
Is there supposed to be a seal or anything here at the axle shaft? [IMG]
I was given a pair of Hedman in-frame headers...
Separate names with a comma.