my 73 is similar... based on Tim's pic, I may be missing that outer piece, unsure what function that serves... secondary/safety spring? edit:...
dane, let me know if this helps... 1973 CJ6... didn't see any other holes in the pan, so I am gonna assume its in the stock position (but PO...
thx zila...
re: 10CSI / 12CSI swap Are the housing bolt patterns the same, or will the stock "motorola" bracket require fabrication? (or do you get a...
re: ring... great advice, right now the battery isn't even in the jeep re: alternator... bigger back story is the mopar injected 258 sitting in...
Always room to understand more, but the question pointed to why everything is run to/from the solenoid was best answered by the corrosion comment...
thanks for the info... want to circle back to the original questions - any reason not to run power to the fuse panel directly from the battery...
now I am wondering what the wire from the alternator to the fuse block actually does... I think I understand the exciter... its there to...
my wife's Volvo XC90 alternator had some type of fault and overcharged her battery... (was a great snowy night in Tahoe when that all went bad).....
hmmmm felt like I understood everything 20 minutes ago, but now back to the drawing board after reading your questions The Alternator to Fuse...
Since I am knee deep in figuring out existing wiring the previous owner did (he replaced stock wiring with the 22 circuit Painless Pre 75 Jeep...
Just for clarification if anyone stumbles on this thread in the future. - Coil posts registers 1.4 ohm - Ballast resistor measures 1.8 ohm - I...
The coil is an Accell Super Stock 8140 , with the following specs: Primary Resistance 1.400 ohms Secondary Resistance 9.2K ohms When i put the...
Read through this, and it helped..: 75 Cj5 Solenoid Question Still have a question though, and trying to understand wiring decisions the...
i replaced my reverse gear in 2012.... found it on amazon https://smile.amazon.com/gp/product/B000FQ21WY
anyone happen to know the hole diameter in the cj7 bezel? [IMG]
digging around the interwebs tonight... something like this may get me in the right direction with a reducer or two... can't find any details on...
Thinking about moving the filler from the passenger rear, to the passenger side. I have read through this thread: Gas filler neck relocation...
thx guys... yeah, the heater control cables have been an item I have been thinking about as well... currently, its all hands on adjustments...
I have some ragged/stripped looking phillips head windshield hinge screws... Any idea of the later model screws will fit the diameter/taper?...
Separate names with a comma.