That AMC 151 is a great engine. I had a 85 xj and put that little 4 banger through all kinds of heck. I had the thing submerged in mud over the...
So, remove the crank and put it back on the stand. You NEED to remove the pistons and check the bore. Your rings cant seat with that much of a...
Nothing wrong with the stock medal tank it is far less prone to rust and damage then a rear mounted tank. Look around, people get rid of these all...
Cool, you got the doors also. Yes it is a Myers the doors are a dead giveaway. Never mind the windshield thing guess you are just swapping that...
It is a Myers top you can see a few on here. It is recommended you brace bottom of the inside with wood before putting it on. These things are...
something to drool over http://www.hotrod.com/techarticles/engine/buick_v6_turbo_block/index.html
Seems like a small hassle but it would weed out the distributor if you put the old distributor on(if it was running good with it) and seen what...
or this http://kansascity.craigslist.org/pts/2365100099.html
Search the craigslist and such in your area. Know when I had my tj the rear seat was the first thing I removed(so my English mastiff could ride...
http://www.thecj2apage.com/forums/i-build-willys-seats-and-more_topic12269.html
Re: Emergency Brake----old school thoughts Yea with a parking break you either use it all the time or never use it. I was always paranoid that...
what. that was a example. you can get the brackets for your jeep through companies like that and use factory parts. Never heard anything bad about...
I when looking for a overdrive I came across a AW372L 4 speed non electronic automatic (It's gear ratios are: [1] 2.83:1 [2] 1.49:1 [3] 1.00:1 [4]...
If you search around (low cost example is this $80 bracket yota axle kit http://www.sky-manufacturing.com/new/detaproduct.php?id=128) you can...
You can convert to disk breaks easily(there are hundreds of kits that use low cost gm factory parts from the 70/80's). This is the setup I plan...
Move this to restro/research
Thank you, that covers the return line pressure issue. If I used a 3 way fuel filter would the fuel return to the tank(recirculating from the...
How complicated is your tube frame? If you don't have a uber mess of tubes just talk with your local 4x4 shop with your measurements and see how...
By the time you consider the cost and the materials you are running around $400 without the dies. This is what I have been drooling over and will...
OK here is my tank design. It uses plates in the lower portion that extent leaving a 1" gap at the end. These plates are staggered so that if...
Separate names with a comma.