Has anyone on here transplanted an early 80’s 4.3L Diesel engine into their CJ? I have a 225 Oddfire in mine right now, have 2 spare 225’s and a...
What PTO driven winch would be period correct for my ‘67 CJ5?
I have a '67 CJ5 with an oddfire V6. Has anyone ever rebuilt them with new weights, springs and pins? The pivot pins for the weights are worn...
I have a line on a front axle Dana 44 from a Scout II. I am debating weather this would be a good swap in for my '67 CJ5. Is there a lot of...
I have a '67 CJ5 and I have completed the disk brake conversion on the front. It has been torn apart for two years. One year of that is because...
I recently purchased a Trac-Loc for my offset Dana 44 I am building and will be putting in my '67 CJ5. I have seen on several occasions people...
What year jeep hanging pedals are best/easiest for an early CJ pedal conversion? I've seen on eBay one set that has one pedal on each side of the...
I know... I'm being lazy. I just don't want to take off the rear diff cover. I crawled under my stock '67 CJ5 to look for the tag on the rear...
I bought this overdrive and want to go through it, but can't seem to separate it. What am I missing? It won't budge. Any help would be greatly...
First the facts, (1967 CJ5 stock axles with exception of the knuckle stud and disk brake conversion, Dauntless V6, T86 trans) I recently purchased...
I have aquired some brackets and pump for my '67 CJ5 with a 225ci V6. My problem is I don't have a pulley for it. Can anyone help me with this?...
I'm going to look at an SM420 trans tomorrow morning to hopefully look at for an upgrade to my '67 CJ5. Is there anything I should look for?...
I am finishing up the well documented front disk brake conversion on my 67 cj5, dana 27, and I am running into a not-so-well documented problem....
I have a question for the masses. I have a '67 CJ5 with Dana 27 front and Dana 44 rear. I am just finishing up my front disk brake conversion...
I am in the process of converting my '67 CJ5 over to power steering and want to know if anyone has any experience in using the bolt-in bracket...
I see on the website the engine ID information; however one of my Dauntless V6 engines has the number DSH040AB. D - domestic S - 1970 H -...
I'm a CJ5 owner, but bought a couple spare 225 V6 engine spares from a guy that had a couple Jeepsters. Along with the engines came this carb....
I was just looking at the brackets to the Smog/Air Pump that I took off my CJ5 225 and they look a lot like the power steering brackets that I've...
I have a '67 CJ5 with a Dauntless V6, T86 trans, and D18 T-case. That being said, I just had the transmission and transfercase rebuilt. The PO...
Separate names with a comma.