Awesome find. Your m170 looks great. These vehicles are awesome and rare but its your vehicle and if you want to make changes "improvements" i...
My 68 cj5 is like that on the drivers side. On the passenger side there is a mounting hole in that same location with a rubber pad inbetween the...
Oh, and the nut is RH thread.
If your talking about the nut that holds the rear output yolk on it is torqued to 120 ft/lbs when assembled. I have used a large pipe wrench to...
I rebuilt my t-14 earlier this year and it also was popping out of reverse. The reverse gear bushing in mine was complety shot. I got all my...
The v6 adapter that you mentioned is probably a t86/t14 adapter. You can redrill it to work with the t90 but you also have to grind some steel...
Herm the Overdrive Guy has used shift towers in good shape if you call and ask him. His price is great as well.
How was the race today?
Yeah I was able to drive my rails out through the rail caps pretty easily. The interlock pill is the only thing in the housing that could be...
Have you tried keeping one rail in the neutral position and driving the other rail out?
Is the interlock pill between the shift rails holding them in? Or did you get that out already?
Very nice. Looks nice and clean. Going to be a great project.
Your right, the valve is part of the fording system. That black part in between the valve and the tubing is the pcv valve. It connects from the...
#5 is the oil pressure sending unit. The "rubber hose" out the bottom is part of the waterproof electrical connector.
Got the tranny and transfer case back in. Cleaned up all the ground straps and decided to try and start the m170. Found a broken melted spring...
Easy way to check if the timing chain is loose is to remove the distributor cap and put a wrench on the crank bolt and rotate the engine back and...
Do you think it jumped time on you? My 68 with a 225 was running fine one moment, then backfired and would not run again. When I got the timing...
Got all my parts for the t90 rebuild. Got everything assembled and went to marry it to the d18 and realized that I bought a large hole d18. My...
my d-18 did the same thing on my 68 cj5. It was hard to tell where it was leaking but after replacing the rear output shaft seal I haven't had a...
And you guys are right, I should buy the second m170 and part it out, but I would like to see someone else buy it and restore it. I just went...
Separate names with a comma.