Put new fuel tank in today and went to start it. Primed carb and fired right up and ran for a few moments then died. No gas in filter yet....
Ok guys, i know i have been asking a lot of questions here lately, but I have another one. After the install of the lock rite in the rear axle...
Right before I started my build, my fuel filter (small clear one) plugged up on me and jeep wouldn't run so in order to get home, I replaced with...
before i begin, let me just say that I LOVE the stock fender look on the '5s and am not looking forward to changing it. With that said, I want to...
Ok, so after all sort of issues with the jeep earlier today, it started running good enough to wheel a little bit. Then all of a sudden it would...
Found out today that my stock speedo cable dont plug into my np435 trans. Was wondering if anyone knows if there is some sort of adapter for this...
Found out today after installing my shifters to the D300 that my original tranny cover will in no way even come close to fitting (I had a...
Hey guys, I am doing a spring over for a dude I met the other day and have a couple questions as to the steering. I know the best route to take...
After researching, i couldn't find a clear enough answer to where to hook the air line from the booster to the manfold. I am running the stock...
Well I finally got the old steering wheel off by useing the bottle jack method I have seen and told about here. Problem is, i lost my...
I posted this question in my build thread and was told that it was prob a better idea to post it here, so here it is. I am trying to remove my...
Alrighty...heres the deal. I need to get some measurments on the jeep to purchase some stuff but have a snag...I cant figure out how to cycle the...
Today I replaced my dana 300's original yokes with new ones with a toyota flange for my drive lines. The originals have the "shroud" attatched to...
Ok, i have been a member here for awhile now and this is the FIRST time i have noticed this section on the builders page. So, i decided to share...
Alrighty yall, ran into a snag today. I started to adapt the brake lines from the original CJ hard lines to the toyota lines on the axle....
I was looking at my saginaw gear box the other day and seen that it had 14:1 stamped on the side along with the part number and so forth. Now I...
I was thinking about putting expanded metal on the top of the roll cage once i was finished with it. I have seen alot of stuff done with that...
Well after puting thos yota springs on the jeep, I found the front is sagging about 2" lower in the front. Now I know once i drop that bigger...
Looking for pictures of people who have done a spring over and relocated their shocks or stretched the front out a little bit and what they ended...
First off, I was wondering if there were any cons to placing the shackle at the short side of the leaf spring and attach the long side to the...
Separate names with a comma.