seems like I did in fact mark left and right. if I did it right, the retaining screw on the 2 bolt bracket should be on the lower ear. *edit, I...
I believe this should be the last of the dana 30 questions. I am trying to distinguish the left and right two bolt caliper mounts that bolt to...
I knew this would haunt me, I unfortunately purchased all new 2 bolt disc parts that were originally on this axle. is there any issues with this...
lots of info! I just thought afterwards that any drum hub is likely not machined flat on the back side. so this means I couldn't have the disc...
what would distinguish drum or disc use? maybe this weekend I will scrounge the hubs with bore gages and check the two inner race diameters. all...
so, another issue! I had forgot that one of the drive flange/hub bolts was cross threaded. this hub is 6 bolt. I have a stash of hubs, but I have...
yes, anti seize now that side slides in effortlessly, the same combination still hangs up maybe needs more cleaning.
good info, I am using the original disc spindles that I took off the axle prior to the rebuild. so no issues in that regard. so indexing 6 times,...
I am wrapping up more or less a complete rebuild with new parts on the dana 30 (2 bolt disc axle). kept the old spindles just refurbished them....
thanks for the heads up! will track em down!
hoping I can be schooled on ubolts and ubolt plates. I need to put an order in tomorrow to get a discount! I am running a dana 30 front, and a...
Can I point out if you choose to invest in a setup kit, make sure the manufacture you order your gears from marks the gears for there respected...
stock narrow track dana 30 with two bolt disc setup. hopefully that can give better answers. yours looks like a dana 27?
not sure if this has any influence, I am looking to run aftermarket aluminum rims at some point. do I need to change my wheel stud lengths? I...
Okay, HUGE improvement, actually just like new. so I measured all my axle ears including the long axle side I assembled prior. they all were out...
wonderful Zila and Daryl you guys rock. looks like with your info and spicers I can safely measure up mine. Zila your measurement is 0.016 out...
best I can tell it looks the same. as Daryl and the spicer dimensions suggests. if you may refer to my post #3, the inside faces. they look to...
Spicer calls for just abit over 2 3/16ths (2.1880) on the ujoint snap wring grooves so your 2 1/4 seems good. Curious what you find Zila. I am...
the measurement inbetween the ears (not sure the technical term) inside measurement inside ear to opposite inside ear. likely a caliper would...
would someone have new dana axle shaft handy they could measure inbetween the ears? my axle ears slightly bent in when I disassembled them few...
Separate names with a comma.