3d printed hood reflector mounts for 1969 model year jeeps I drew these up and printed them out. Im using PETG filament which is supposed to be...
Just in case anyone ever wondered what the internals look like on a Jacobs chuck... [IMG] Found out part of the reason my chuck keeps popping...
https://somarmotor.com/axle-parts-diagrams-front-dana-30/ Ok, so I built this axle before I really knew what I was doing, but looking at the...
I've got a m12 cutoff saw and found out they are coming out with a new belt sander. Think the bare tool is like $250. So someone actually makes...
https://www.kaiserwillys.com/transmission-front-bearing-retainer-cap-4-134-fits-46-71-jeep-willys-with-t-90-transmission Anyone know what's...
[img] It has begun. Ran when parked... 2 years ago. Just had not wanted to start since then. Engine allready has issues with rust in cyl 2 I...
Not much going on at work since I'll be out for the next couple weeks. Took some measurements this morning and bent some stainless up. About to...
This is has been listed locally for a bit now. Mated to a d20 with pto. Can anyone tell from the pictures how useful this pile of parts would...
Decided it was time to improve the hard top remover for the jk. Before I had to move all my stuff from the corner, crank the top up off the jeep...
I'm thinking about getting my fuel injection setup installed this winter finally. Something I didn't think much about till now is the fuel...
Anything special about an old original key switch??? I've got power to starter when cranking. Power to battery always. No power to accessories....
I got the brass for this a couple years ago but found out i didnt have the tools to finish it... Had some time to kill at work last week so...
Question for everyone about the hood reflectors on the 69 cj5's. I took mine off to see about doing a 3d print and not sure I have what everyone...
i have been neglecting my old '48 model M for a couple years now. Havent kept it covered up, havent been able to start it so sits more and more...
So my side locker came yesterday finally and i managed to get it put in place before i left today. Still needs to be bolted on but will deal with...
Picked up a Milwaukee 18v weed whip and it came with a free blower. I havent trimmed all year yet and ran it around the yard with all the trees...
For those of you that know the intermediates from the earlys... I have what i thought was a soft top to fit my 69.-the tan top. The black one...
The plow jeep is running on 2 cylinders at the moment(barely). I get about 1/2 cup of fuel at the carb in about 15 seconds so should be good on...
Warn 8274 Winch Mount Starting it off with this mountimg plate. Looking to get a piece of steel tomorrow for the bumper. I bent the origonal 2...
Anyone ever cut the spokes on an original and the wheel rim? Looking for a smaller diameter wheel but still want the factory look.
Separate names with a comma.