Hi Jeepdaddy from Colorado. I've just done a frame-off resto on my 46 2A. It has the Dauntless V6 and prior to this reincarnation It had a 2GC...
I was wondering if anyone here has put 11" brakes off of a CJ5 on a Willys pickup truck with a Dana 53 rear end/
Rats. That's what I figured, but I had to ask. Hope you have a Merry Christmas.
Hey Whellie. Do you still have this Dana 53 Power Loc? If so I'd be interested.
Good Afternoon fellas,
I rebuilt my D18 a short time ago and afterwords I noticed that when backing up my Jeep kinda pulsed. It was fine going...
I used a Cherokee column in my 3A with no problem. I notched the drivers side body mount to the left a little but that was all. I even used the...
Are those clamps still available anywhere?
Where do you guys get your windshields? Do you thing regular auto glass shops carry them?
Not to hijack a thread but what are the dimensions of a 3A windshield, please?
So how do you guys like this heater? Does it do the job?
You can go to Home Depot and get a half dozen 1/4" pipe plugs and screw them in tight w/loctite
Mine originaly just went through a rubber grommet in the firewall and then curved around and went down to the frame to a small round bracket and...
I just picked up a TC-3 that's in decent condition considering the age but the right fender got trashed somewhere along the way. Do any of you...
The rack is mounted under the left frame rail, not under the radiator and it just pushes and pulls the passenger side spindle arm.
I agree. A 650cfm vacuum secondary with center hung floats will work much better and have better low end torque.
I did it on my 2A. I know it's not CJ-5, but it was easy. I used the Cherokee power steering box and dropped pitman arm(which by the way took out...
A Holley 300-22 will fit both.
I'd think parts of the cotter pin would have to be left in the hole in the axle or in the dust cover.
Don't forget to make sure that your oil pump is lined up with the end of the distributor shaft when you install it.
Separate names with a comma.