Sounds like you may have front 11" wheel cylinders on the rear. Were your 11" brakes used in a front application ?
I think I would purchase the...
Get the service manual and read it.
Covers everything you've asked about.
No. Different bolt pattern.
Junk in my opinion.
Then get the other special tie rod end that will have the opposite angle and should give the clearance.
Seems like a prime candidate to ditch that set-up and go with the one piece long tie rod.. moving the special tie rod end out to the knuckle.
My manual just says disregard, for factory use only.
Good luck in your hunt.
The tag shows how the Jeep came from the factory.
The paint and trim codes are on the tag.
What is this paint option code you speak of ?
...and they come from factory with knuckle studs installed.
While researching a Ramsey winch question, I found this photo in the Ramsey factory brochure.
Can't say that I have ever seen one on a vehicle or...
Have you confirmed what the actual problem is/was ?
That and the wording in the ad.
Hardship, must sell, but not in any hurry to sell.
Just do what the recall states, nothing more, nothing less.
It was called TranLub recall. or something like it.
Seems about 50% we checked had the...
I would just re-thread the tip of the cane if that's all that broke.
Choose replacement knob of your choice.
Take those god awful side steps off.
Whitewalls were the old tires ?
Ditch those wheels too.
I would replace the tank with correct tank.
17 gallons hard to beat from factory.
I think there are better and safer vehicle choices for a youngster to drive back and forth to school with.
Driving old iron requires a lot of...
An original long gone...
Separate names with a comma.