(y) What a difference!
I do not run a heater or hoses on either on my Dauntless V6 powered Jeeps, no issues here.
They sit slightly proud, shims are used to set preload pressure.
Here is an interesting thread on the subject....
Looks like the speedometer cable connection is at least one source of the leak.
Seems like an exhaust shop would have those in stock in various sizes, or could get them.
The slave is Wilwood 260-1333.
I used this ball stud to get the correct leverage on my 70 Jeepster/Commando with the 225 Dauntless & T-14 transmission.
I used freeze plugs. The brake drum covered most of the hole but mine still had a small area exposed on each shaft. The plugs were inexpensive at...
Keep it !
Car shows and cruise in's are becoming more numerous again. You put a lot of work into it so maybe keep it around a little longer if you...
Remove the spark plugs and squirt a light oil such as Marvel Mystery Oil into the cylinders and let sit for a while to soak the piston rings. Have...
Well...you bought the pin striping tool a while back so you may as well try it out !
It looks to be in decent shape.
You may be able to use a thread restoration tool. The one shown below has 8 different thread pitch/sizes, it is used to straighten & cut existing...
Yes, you can stuff the intake while cleaning up.
Many manufactures engines of this vintage have an exhaust crossover port in the intake manifold...
Check the vertical weld by the pivot point / grease zerk area, in the picture it looks like it may have cracked.
The garter spring side of the seal always goes to the fluid side when installed.
A frame off job, your going in deep...I like it (y)
Good job with he pictures too, keep them coming.
You need a tetanus shot just to look at it.
Separate names with a comma.