I would not swap anything else than a chevy LS base engine. Like other said, going from a v8 to v6 you will regret. 4.3 tbi style engine or LS...
I have gone from a 360/t18 granny low to a LS/th350/dana20 set-up. You need a oversize cooler for the transmission. Also a dana 300 will be better...
I would say, if you dont have one in the front, start by putting one there. As for the rear, when i did my frame swap i put on in the rear (i'm...
Soft hammer, hit it between the race bearing...it should take some lose.
i have my trail tire (36 12.5r15 tsl bias). The only thing i work out to help is to remove the rear spare tire. I have tought about removing the...
Thank you, i ordered the one with the smoke lens
I think that every cj5 owner have experience this at least one time in their life ahah
Do you have the brand of the turn signal, i realy like them
Yes, the last run with the C10 was a realy good one. I'm really happy with the jeep, the hard work pay off :)
Here some other shot taken from spectator [MEDIA] [MEDIA] [MEDIA]
So i had a great tome last week-end doing some mud drag. Jeep was competitive and i aint broke nothing this time. In the V8 class with some...
Th350 with a sbc with an adapter to the th350 and dana 20 is about 1" longer than an amc v8 t18 and dana 20 transfert case. Transmission is longer...
i was relativing to my own experience. I had the housing broken on passenger tube, and it started craking way before i made those jump ahah.
With all the added weight, do you plan on reinforce the rear axle ?
For you're speedhut installation, i really suggest buying deutsch connector to connect cluster and dash wiring together , it made the install way...
Happy Monday to everyone. I had a good week-end to test out my spring modifications. I had couple's problem that were easy to fix. First of all...
Great idea about the folding table. I was wondering what you were up to ahah
set10
Those swamper arent nice on the road, i understand the need for a road friendly tire :P
I have to stop reading other idea :P I have those part laying around and now i will have another project ahaha Nice work as usual :P
Separate names with a comma.