I agree from what I have observed.
I have a recent rebuilt Jeep with near 100% OEM NoS parts. The fuel pump is an AC 4693 that was mfg back in...
Great info Howard. I’m just not familiar with jeepster/ commando parts.
My mistake; Tim’s right.
It is possible to convert to a single tie rod system without using a double knuckle via integrating the special tie rod...
Not an either/or choice here; you get both if you convert.
When you install a 2 hole knuckle to a D25 or D27 axle, the steering ratio (advantage)...
The Jeep “76” box is ideal for most applications yet I fully agree with all above statements exactly.
So pay close attention to the pitman arm...
I imagine 3.73 ratio would be best unless a guy did lots of off road with it. Then the optional 4.27 would be better.
I agree with the nearly...
I have a known correct original manual box and the stick out length is 3-3/4”.
I have a solid DJ inner column and the OAL is 34-3/4” .
God save the puppies !
I vote voltmeter ….
Not exactly familiar with the 72-75 cj part.
Is that a solid shaft or hollow ?
And what’s the overall length ?
I would expect it’s solid like the...
You need the inner column shaft for a 1972-1975 cj ?
Aha ! Never noticed that.But now I see it.
I don’t find any other references to that term.
I was only joking, but honestly I never before saw it being called a “pot joint” in the factory TSM.
What particular TSM do you have ?
Yeah I run into the same issue; no boots to fit the round intermediate steering shaft.
The connection is called a bellcoupler not a pot joint....
Some lucky guy on the west coast will want in on this deal:
Dave, letting you know I’ll pass on the timing cover, I have one…and thanks for posting your stuff
Not right, I have that lever but thanks for looking…
I think I need an early style timing cover,
Early Fits gasket on the left…[img]
This air cleaner is correct for 1970/1971 Dauntless.
Here is the riser on eBay:
Here is the decal on eBay:...
I figure my Jeep is around 2500 -2750 pounds of vertical lift.
I use a 5/1 safe working load limit intended for vertical lifting applications.
Your 1970 obviously has the original cable controlled clutch release.
The lever on your new pedal pivot shaft was used on pre 1970 CJ’s with the...
Separate names with a comma.