Cheap scout hub parts…looks like a two hole knuckle for steering conversion. https://www.facebook.com/marketplace/item/700959017607155/
Does anyone have experience with flat towing with the tow bar attached to the shackles? Currie Jeep Towbar System - Flat-Tow Your 4x4...
Does anyone have a solution? I've searched, but the closest I found was one that a member (for a bronco?) said was too large. I'm using the old...
This is all aftermarket stuff...I gave up on the original cluster a long time ago. I use a 15 gal MTS tank, an MTS sender and an autometer gas...
I did the sidekick disk brake conversion awhile back and I can’t get the passenger side to stop dragging. I thought it would sort itself out and...
Well I’ve been using this site for a long time, so guess I should do a build thread to help others not make the same mistakes I have and get help...
Here is my summary on the Rocky Road YJ spring lift, for those who might find it helpful. Again, thanks to those who did previous write-ups with...
i finally got my power steering hoses for my Saginaw swap. I filled up the pump tank, started it, and no power assist. So I gave it some gas and...
I finished my rocky road yj swap and Saginaw conversion and took it in for alignment. I went to a chain place and not my usual due to distance and...
I’m wrapping up a Saginaw power steering conversion and am stumped by the power steering hose. I bought one or two I thought might work but they...
I am stumbling through a saginaw swap and are to the point of replacing my driver's side manifold. I was able to get all the bolts out without...
Has any one put suspension seats for a sidexside/utv in your jeep? I'm looking at the low back version of Rhino Replacement Seat - PRP Seats....
Looking for yall's $0.02 After having issues for awhile, my rear 19 spline Lockright finally ate itself up this weekend. It is a...
I installed a HEI kit on my v6 from CRT performance a few years ago. It would intermittently fail to start due to lack of spark, but I was always...
I am thinking about converting my unused manual choke knob/cable to a hand throttle knob/cable on my v6 with the 2g carb. Does anyone have any...
I am in the process of finishing up (I hope) a sm465 install with the AA short adapter. In its current stage: the body is on, the floor board...
My current 1967 jeep is set up with a d18 t-case without a parking brake attached to the output flange. If I install a stock drum parking brake...
Looking for yalls 2 cent's worth. It's a 1967 Jeep V6 that is driven 75% off-road and sees highway speed rarely/briefly. I have done the 11"...
I have about 1/4" of endplay on both sides of my axle (can pull the axle/hub in and out 1/4"). So much, it is causing my drums to rub the backing...
I noticed the front shackle brackets are welded on about 1.5 inches narrower than the pivot brackets for the same springs. This makes my front...
Separate names with a comma.