Jeep has 11” drums at 4 corners and a slick clutch linkage (the only good thing bubba did) I have made a throttle linkage and pedal so hanging...
I have a 71 cj5 that I am converting to Saginaw power steering. My most recent issue is figuring out how to mount my 2” diameter flaming river...
I would run a rubber “nipple” right after pump or right before carb. I like having a little wiggle in the fuel line. But I don’t like how it...
My father in law carries sawdust in a ziplock in his hunting rig. Swears it will patch pinholes in the cooling system.
I use a cheap electrostatic setup ($200 IIRC) for coating anything metal. You don’t need the expensive paint if you have access to old school oil...
That’s a lot of body lines intersecting in one place. Your work looks great!
local machinist made some new frame horns (originals were ripped and cracked at spring hangers). Got those welded in and plated, bumper, spring...
You will have to cut/modify trans cover for the swap. Single stick vs twin come through the floor in different places. So you might as well make...
My legs are too long to crawl into a high hood with anything in the way. I figured it opened like a door :) And I believe you about the Jackies....
Looks great. Which way does it swing? Love the wheels.
With my ‘71, the top of the hole for fuel filler was 7 1/2” from top of tub. 3” diameter hole. Rubber from FLAPS or q-tec.
I have used RAM parts on multiple projects with no complaints. But I have no experience using them on a Buick.
Yes it’s a 4 bolt. And it has the larger sbc oil pump. Not a lot of info on the old marine 4.3s. But from what I understand it has a little cam,...
I got the Jeep with the gm tranny installed. I had a stock drivetrain ‘41 and ‘65 4cyl 3 speeds. And a ‘66 dauntless with a 3 speed. And I...
Ha! Brakes, cooling and steering. Then lockers and gears and THEN tires. My goal is to be ready by summer. Naturally aspirated so I’ll probably...
Was given a ‘71 cj5 than has a SM465 mated to the Dana 18 and no motor. I scored a free boat on Craigslist that needed too much work make...
Cost of adapters + time to install + new clutch t/o bearing + mounting to tc crossmember + cutting/fabricating new floorboard and tranny tunnel +...
Bring in a stray and rehabilitate so that it is safe to go to new home. It’s like a “no kill shelter” for old iron.
One attaches near where the tub meets the frame. The other attaches next to where the fender meets the fire wall. Both attach to the bottom of the...
I have had great success with all of their products. Soft shackles, recovery ropes and winch lines. All made in USA and they donate some of their...
Separate names with a comma.