Can any one tell me the housing diameter on a Naco tail light? Depth would be nice too :)
There used to be on one of the the yahoo trailer groups plans for canvas top hoops that were used on the civvy models, anybody got these saved...
My poor little Iltis trailer has been suffering from living by the sea :( The springs & tongues are in pretty bad shape so it's time for a fix up...
[MEDIA]
[IMG] Jimmy The Junkyard Dawg! 1 day ago Colorado, the Denver U-Pull-And-Pay [MEDIA]
Introduction- [MEDIA] As Tonka gets older (or maybe it's me) I'm finding the effort required to crank the big'ole'bus wheel in stopped or low...
Looking for a good, preferably immaculate, worm tube for a F4 box, apparently it should be 41 & 5/8" long. Thanks, H.
Due to an ongoing project I found I had a pressing need for this- [ATTACH] [ATTACH] [MEDIA]
I'm seeing a lot of rust but undoubtedly there's some rare gems in there somewheres. [MEDIA]
Looking to beg/borrow/steel/buy a 7° tie rod end reamer
If I could have found one to buy I sure would have. But I couldn't :( [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Anyone got the TRW p/n for the stock sized left hand thread tierod end?
I picked up a used dust collector a few years ago after a major project involving the table saw literally filled the garage with sawdust. Whoever...
I started this in 2005 & then life intervened- Foundary It's been buried under various piles of junk ever since but the confluence of cleaning...
So I've finally had it with with miss-matched wrenches and 7/16" & 10mm's literally disappearing before my eyes leaving incomplete sets garbaging...
Have wanted a white board in the garage for a bit so finally got around to it. Not many options for mounting space so I had too get creative....
Work in progress. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Maybe now the &$%#! dust will go into the...
[ATTACH] Just curious about how the heck they made this stuff. It's obviously (?) a piece of tube that, I'm guessing, got drawn through dies to...
Got to use the mill today on a small project, I used it to make a cable reel out of an old oil filter :) [ATTACH]...
I've been slowly putting Tonk back together , slowed down radically by some family illness. I finally went to move him yesterday & found that the...
Separate names with a comma.