What kanban app did you download? I use that process at work
Got it from Barney’s Jeep Parts from the info above. Great guy to work with. Very knowledgeable.
I need to paint it black but it looks...
Thanks for everyone’s suggestions and comments.
I was able to locate a NOS replacement as well as the 5x8 drivers side mirror as shown in this...
Would a dremmel tool with a cutting wheel work? Easy to control so you could cut through just the bed liner along the seam of the panels
not exactly what you’re looking for I know but thought I’d post just in case it helps
the ubolts are indeed 1/2” diameter.
I can’t address the flexing since I haven’t had it in that situation yet. But I’ll try to take measurements and additional pics when I get home...
It actually does sit level But you’re right, I don’t have a winch installed yet.
Here’s my CJ with 2.5 inch BDS lift and 31x10.50x15 BFGs. Rides great. Very satisfied.
I looked earlier today at the link provided above but didn’t see them
I’ll give you a call tomorrow.
thanks for responding to the post!
congrats on getting to this point!
Thanks for the sources. I’ll check them out.
Thank you for the info. I’ll see what I can find out there. Thanks for providing the part number as well.
I have a 1970 CJ5 that has this mirror.
1). Is this a stock mirror for this Jeep
2) if it is stock, is it possible to fix the...
Decided to spend a cold rainy day polishing the Jeep.
Step1: wet sand with 2000 grit wet/dry sandpaper;
Step2: buff with McGuire's cutting...
Here’s a pic of the connector going into my voltage regulator on the fender. Yours does look similar.
Not sure this will help but here’s a pic of the wiring diagram from my service manual
Thanks a lot! I spewed half my beer over this one! :rofl:
You bet. I started going through the Jeep top thread last night.
you have some great photos on your page. I’ll definitely check them out after...
Separate names with a comma.