I built them myself, even powder coated them.
It did settle after I installed them.
This is when I first installed them. You can see the shackle position.
After they settled.
I have 3 1/2" lift springs with a 1 1/4 body lift on 33" tires. These springs are really soft. I thought it would be too high, but it's really...
I rubber mounted mine to the right inner fender under my battery.
The exhaust gets really hot so try to keep the ECM away from it.
Should work now. Forgot to check a box when publishing.
My M38a1 is a little quieter. You may need a new intermediate shaft and bearing.
Not sure, they sent me new ones when one broke.
The part number for these Warn locking hubs is 36655. (30 spline)
Warn FF has hubs specifically designed to not come unlocked. They have set screws. FF use only.
I broke one of these hubs, but I have never...
If you use factory exhaust manifolds. The driver's side manifold need to be from a Chevy Astro Van. For this manifold. I had to machine a 1/4" off...
I used a 1995 TBI 4.3ltr mated to a SM465.
That's what I have.
This was a picture of my old engine before the 4.3ltr.
Updated photo with the 4.3 ltr.
The master cylinder was changed...
How about this crazy idea?
I see you have a big opening for the fuel pick up. How about drilling holes in the bottom sides of a metal can. With...
Explain to me how air gets into the filter?
I've had experience on venting the under the seat tank. The tank ventilation should be plumbed with a...
Did you try adjusting the clutch?
If you are having a body shop do your tub. I would have them do the windshield as well. I would just strip the frame of all the parts and let them...
My 33X12.5X15 tire has been bouncing around on my M38a1 for years now with no problems.
I'm even missing the back support channel. I would suggest...
Being they are removable panels. I didn't use anything. I'm confused why something is needed between them. Air/ water/ noise? Haven't noticed any...
I used metal screws designed for plastic.
My 73' Dana 30. I had to have the back side of the hubs machined to except the disc's.
My pre-fabed shifter from Herm wasn't even strong enough to shift the overdrive. I had to reinforce it.
Separate names with a comma.