Careful with chemicals on that type of decal. It might destroy it. I would wet sand it.
Thats close to me.
I pulled the tub off the rotisserie so I could patch the floors and replace hat channels.
The classic ent. hat channels fit really well...
Well, that was poorly executed...
I'm not sure if the one pice bell housing is a score. It can't be used on a T18 swap.
At least it is a T14 and not a T86.
Log into Facebook
Needs some work.
I make all my own driveshafts. Its pretty easy to do.
This topic has been covered.
T98 And T18 Parts Compatibilty
Discs are the way to go now. Especially with the eee parking brake kit for the rear.
Ever look at 4wd tractors? Small tires in the front, big ones in the back. Different gear ratios to compensate for the tire size.
I'll have to check.
I broke mine off too and welded it back on. Its cast aluminum. It has been working great ever since.
What kind of material is it? Find a local welder to weld it up properly and have it repaired the right way, or send it to me.
This is what I was talking about. The ratio of x on the knuckle to the bell crank is 1:1. By using the outer hole, the leverage is increased, but...
I had to do a Y link setup on my jeep. The issue is, the center to center on the bell crank to the tie rod end is shorter than the center to...
:clap:Another useful power steering thread!
I tried using the 2 hole knuckle on my jeep (D30 version) and I wasn't able to steer lock to lock...
Both of my 3As have these washers.... They hold the coil clamp to the block.
I have one as well.
I will be getting this for snowshoe. The starter in it doesn't sound great.
Separate names with a comma.